7-Speed S-Tronic Direct-Shift Gearbox (DSG/0B5)

From Ross-Tech Wiki


General Information about this Transmission can be found in the Wikipedia entry. Additional information can be found in the Official Factory Repair Information.

Coding

  • When replacing this Mechatronic unit Component Protection fault code(s) may be stored.

Basic Setting

Prerequisites:

  • Transmission fluid level correct
  • Transmission fluid temperature between 40°C - 100°C. (one user reports this needs to be below 60°C)
  • TCM fault free however it is strongly recommended to check/clear all Powertrain controllers faults also.
  • Key on, Engine off
  • Selector lever in P


All 3 Basic Setting operations need to be completed in the order listed below

[Select]
[02 - Auto Trans]
[Basic Settings - 04]

Select Erase counter for start and stop processes
[Go!] to activate the Basic Setting.
After the result of Finished Correctly or Not Running appears click [Stop]
[Done, Go Back]

Start the Engine and leave the Selector lever in Park

[Basic Settings - 04]
Select Clutch valve calibration [Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]

Select Distance sensor calibration
[Go!] to activate the Basic Setting.
Clunking noises from the transmission are normal
After the result of Finished Correctly appears click [Stop]
[Done, Go Back]

Switch off Ignition, wait 10 Seconds and switch it back on.
[Fault Codes - 02]
Check and clear any fault codes
[Close Controller, Go Back - 06]
Perform a test drive and check for fault codes again after doing so.

Special Notes

forums.ross-tech.com/showthread.php?2293-Audi-A4-2-0-TFSI-Quattro-s-tronic-0B5-%28DL501%29-problem&p=23158&viewfull=1#post23158