Audi A6 (4F) Parking Aid

From Ross-Tech Wiki

(Redirected from Audi Q7 (4L) Parking Aid)
Jump to: navigation, search

Contents

Coding

  • 0?xxxxx: Optical Illustration
    • 0 = without Optical Illustration in Display
    • 2 = with Optical Illustration in Display
  • 0x?xxxx: Trailer Hitch/Rear View Camera
    • +1 = Trailer Hitch installed
    • +2 = Rear View Camera installed
  • 0xx?xxx: Transmission
    • 0 = Manual Transmission
    • 1 = Automatic Transmission
  • 0xxx?xx: Specification
    • 0 = ECE Countries (without reinforced bumper)
    • 1 = ECE-Countries (S-Model without reinforced bumper)
    • 2 = USA (with reinforced bumper)
    • 3 = USA (S-Model with reinforced bumper)
  • 0xxxx?x: Chassis
    • 0 = Sedan
    • 1 = Avant (Wagon)
    • 4 = SUV
  • 0xxxxx?: Model
    • 6 = Audi A6 (4F) / Audi Q7 (4L)


Adaptation

Rear Buzzer Volume

[Select]
[76 - Parking Aid]
[Adaptation - 10]
Channel 001
[Read]
Adaptation of the rear warning buzzer volume.
Range: 1...9
[Test]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

Rear Buzzer Frequency

[Select]
[76 - Parking Aid]
[Adaptation - 10]
Channel 002
[Read]
Adaptation of the rear warning buzzer frequency.
Range: 1...9
[Test]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

Front Buzzer Volume

[Select]
[76 - Parking Aid]
[Adaptation - 10]
Channel 003
[Read]
Adaptation of the front warning buzzer volume.
Range: 1...9
[Test]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

Front Buzzer Frequency

[Select]
[76 - Parking Aid]
[Adaptation - 10]
Channel 004
[Read]
Adaptation of the front warning buzzer frequency.
Range: 1...9
[Test]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

Confirmation Sound

[Select]
[76 - Parking Aid]
[Adaptation - 10]
Channel 005
[Read]
Adaptation of confirmation sound when switching into reverse gear.

  • 0 = Confirmation Sound inactive
  • 1 = Confirmation Sound active

[Test]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

Factory Defaults

[Select]
[76 - Parking Aid]
[Adaptation - 10]
Channel 006
[Read]
To reset all values to factory defaults, save 0 as new value.
[Test]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]




Unless otherwise noted, all content on this site is Copyright © 2000-2010 by Ross-Tech LLC. All rights reserved.
"VCDS" is a Registered Trademark of Ross-Tech, LLC.
Ross-Tech is not affiliated with the Volkswagen Group in any way.