VW Golf/Jetta/Bora (1K/5M) Tweaks

From Ross-Tech Wiki


Ross-Tech is not responsible for any damage or problems that may result from following these instructions. They are to be used at your own risk.

These instructions apply to the VW Golf/Jetta/Bora (1K/5M) and most of the 2009 and older Audi A3/S3 & A3 Cabriolet (8P) chassis vehicles.

Note: For many 2010 and newer vehicles, including the VW Golf/Golf Plus (5K/52) + and the 2010 VW Jetta (1K/AJ) models, a newer 09-Central Electronics module (BCM) replaces the previous generation 46-Central Conv. module. Those models are not covered on this page.

  • It is always recommended to perform a complete Auto-Scan and save it prior to coding changes. Please see the Online Manual: Auto Scan Screen
  • Never Copy coding from a different vehicle and Paste it to your module(s)!


The installed control modules vary by vendor, firmware level and equipment level, some of the noted tweaks may not be supported by all control modules / vehicles.



[09] - Central Electronics

Lighting

All modifications are found in Found in [Coding - 07] > Long Coding Helper unless otherwise noted. Click on each of the Bytes and Bits for the documented options and check or un-check the appropriate boxes as shown in the example below:

[Select]
[09 - Cent. Elect.] Or the module you intend on tweaking as per the list below
[Coding - 07]
[Long Coding Helper]
Click on each of the Byte numbers in row 3) and you'll see the selectable options below. Check or Un-check the boxes for the desired results. Example: Daytime Running Lights (North America)
Close the Long Coding Helper by clicking the Windows X box on the top right of the screen or clicking the Exit button on the top left of the screen to send your altered Coding value back to the Coding screen.
[Do It!]
.

Daytime Running Lights - The systems are coded differently depending on the market:

  • "Daytime Running Lights (Scandinavia) active" should result in ALL exterior lights running
  • "Daytime Running Lights (North America)" should result in headlights Only lights running


Fogs as Daytime Running Lights when applicable

  • Enable "Daytime Running Light via Fog Lights"


Daytime Running Lights Dimming If DRLs are Halogen bulbs (not Xenon) the dimming resolution may be adjusted.

  • Select the Byte with "Daytime Running Lights Dimming" "Decimal Value (Resolution: 1%)" and alter the value.
  • Additional Light Dimming bits are available for other lighting circuits.


Front and /or Rear Fog Light dimming behavior with High Beams or Trailer
Depending on equipment level, additional coding bits may be available.

  • Front Fog Lights deactivated with High Beam
  • Rear Fog Light Deactivation with Trailer active


Cornering Lights via Front Fog Lights active when applicable

  • Enable "Internal Turn Light Control Algorithm active"
  • Next, Enable "Turn Lights via Fog Lights"
  • Additional [Adaptation - 10] options may be available for dimming duration activation/deactivation

Notes: After Cornering Lights via Front Fog Lights is active, the lights may work under the following conditions:

  • The headlights must be turned on and the steering wheel must be in the turning direction.
  • The headlights must be turned on and the turn signal must be on in the turning direction.


Comfort Turn signals

  • Comfort Turn signals may be turned On -or- Off via coding. The number of flashes cannot be adjusted.


Emergency Brake Warning active The Brake Lights should flash under Panic stopping conditions.

  • Enable "Emergency Brake Flash Light active"


Coming Home / Leaving Home

Modifications are found in Found in [Coding - 07] > Long Coding Helper. Click on each of the Bytes and Bits for the documented options and check and un-check the appropriate boxes. Additional Adaptation -10 Channels should be available after enabling coding options.

Coming Home Several Bits may control CH options such as On / Off and Manual or Automatic.

  • "Rain-/Light sensor installed"
  • "Coming-Home active"
  • "Coming-Home Logic (0 = Old / 1 = New)"
    • Note:If the vehicle is not equipped with an "Auto" headlight switch and a (RLS) light sensor the results may vary. The description should be found in your owner's manual.

Leaving Home

  • "Coming-Home Mode via (0 = Personalization / 1 = Lightsensor)"
  • "Assistance Driving Light & Leaving Home active"
  • "Leaving-Home Variant (0 = LH in LDS / 1 = No LH in LDS)"



[17] - Instrument Cluster

Seatbelt Chime May remove the light as well

  • Found in [Coding - 07].

Unlike the 09 and 46 modules the Instrument Cluster uses conventional Short coding. The coding is the sum of numbers that need added or subtracted from the proper position(s).

Using a 1K chassis VW example we'll look at the third and fourth digits in the coding (00??x0x). Add the values for the options together and put them in the third and fourth digit location to get the correct coding:

00 - No available equipment
+01 - Brakepad wear sensor warning active
+02 - Seatbelt warning active
+04 - Washer fluid level warning active
+16 - Sedan (Jetta)

So, if your stock Soft Coding is 0023203 and you want to remove the seatbelt chime, put in a new value of 0021203. If the coding chart in VCDS does not match the above example use the information available in the pop-up balloon.

  • Additional "Seatbelt Warning" options may be available under [Adaptation - 10]


Modify Service Intervals Mileage and Time

  • Found in [Adaptation - 10].

Depending on the vehicle configuration, options for Min. Distance and Time to service may be altered.

  • The [SRI Reset] function is used for normal Service Reset procedures.


Fuel Gauge and Fuel Consumption Adaption when applicable

  • Found in [Adaptation - 10].
    • Consumption Correction
    • Fuel gauge adaptation



[46] - Comfort System

Windows

Found in [Coding - 07] > Long Coding Helper

Windows up via remote Comfort Operation (via Remote Control)

  • Uncheck the box for "Comfort function power windows/sunroof via remote control inactive"
  • Check the box for "Comfort opening power windows via remote control active"
  • Check the box for "Comfort closing power windows via remote control active"
  • Check the box for "Closing sunroof via remote control active"

Notes:

  • For some reason, VW does not allow the sunroof to be opened using the remote, only closed, despite the presence of a checkbox indication for that feature.
  • When the additional "Comfort Function automatic Closing" bit is enabled in the coding the windows should automatically roll up after briefly holding the lock button on the remote.


Auto Closing Sunroof & Windows via Rain Light Sensor
Requires the (RLS) Rain Light Sensor. This will require coding the [46] - Comfort System module AND the [09] - Central Electronics module Sub-System RLS.

  • Comfort function power windows/sunroof should be enabled as explained above
  • [46] - Comfort System module using Coding, Long Coding Helper
  1. "Rain Closing" (1 = permanent) must be enabled
  2. "Comfort Closing via Rain Light Sensor (Rain Closing) inactive" Cannot be enabled
  • [09] - Central Electronics module choose the Sub-System RLS (from the drop-down menu) using Coding, Long Coding Helper
  1. "Rain Closing active" must be enabled

Notes:

  • This may not be supported on all vehicles.
  • Depending on the configuration an additional Rain-Closing menu may be available on the dash (MFA/MFD/DIS)
  • Due to feedback that varies greatly some tips to test the system include:
    • Sprinkle/spray (for example with a water spray bottle) a small amount of water on the sensor.
    • Test the system after locking the vehicle with all doors, hoods and lids shut for 10 minutes.
    • Try the wiper stalk in the OFF position and the Auto/Intermittent positions.
    • Search forums if this isn't working ;-)

Alarm and Locking

Options are primarily found in [Coding - 07] > Long Coding Helper. Additional Adaptation -10 Channels may be available after enabling coding options.

Alarm Confirmation via lights and horn

  • "Locking Confirmation (Horn) via Remote Control"
  • "Locking Confirmation (Blink) via Remote Control"
  • "Unlocking Confirmation (Horn) via Remote Control"
  • "Unlocking Confirmation (Blink) via Remote Control"

Auto-Lock

  • "Auto-Lock (automatic locking from 15 km/h)"

Auto-UnLock

  • "Auto-Unlock (unlocking after removing key from ignition)"