View source for Immobilizer I ECU Swapping

From Ross-Tech Wiki

← Immobilizer I ECU Swapping

You do not have permission to edit this page, for the following reason:

---

You can view and copy the source of this page.

__FORCETOC__ This procedure details how to swap engine control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I. == Determining IMMO-ID == '''[Select]'''<br> '''[25 - Immobilizer]'''<br> ''or in vehicles with Immobilizer included in Instrument Cluster''<br> '''[17 - Instruments]'''<br> Look at the first "Extra" field. You should see something like: ''Immo-ID VWZ7Z0W0648696''.<br> '''[Close Controller, Go Back - 06]'''<br> == ECU Swapping (Audi) == '''<u>Prerequisites:</u>'''<br> * Battery voltage at least 12.0 V.<br> * Valid/matched key(s).<br> '''[Select]'''<br> '''[25 - Immobilizer]'''<br> ''or in vehicles with Immobilizer included in Instrument Cluster''<br> '''[17 - Instruments]'''<br> '''[Adaptation - 10]'''<br> Enter 000 in "Channel Number".<br> '''[Adaptation - 10]'''<br> Channel 000<br> '''[Read]'''<br> '''[Save]'''<br> '''[Done, Go Back]'''<br> '''[Close Controller, Go Back - 06]'''<br> * Switch OFF the ignition and after 5 seconds switch it ON again. * Make sure NOT to start the car within the next 2 minutes. After that, try starting the engine. == ECU Swapping (Seat/Skoda/Volkswagen) == '''<u>Prerequisites:</u>'''<br> * Battery voltage at least 12.0 V.<br> '''[Select]'''<br> '''[25 - Immobilizer]'''<br> ''or in vehicles with Immobilizer included in Instrument Cluster''<br> '''[17 - Instruments]'''<br> '''[Login - 11]'''<br> ''There are 2 possibilities how to enter a PIN, choose the one that applies for you.'' * '''4-digit PIN''' ** Enter zero followed by the 4-digit PIN. ''For example, if your PIN is 1234, enter 01234.'' * '''7-digit PIN''' ** '''[Use 7-digit PIN/SKC]''' ** Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code. ** '''[OK]''' ** VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX". '''[Do it!]'''<br> '''[Adaptation - 10]'''<br> Enter 000 in "Channel Number".<br> '''[Adaptation - 10]'''<br> Channel 000<br> '''[Read]'''<br> '''[Save]'''<br> '''[Done, Go Back]'''<br> '''[Close Controller, Go Back - 06]'''<br> * Switch OFF the ignition and after 5 seconds switch it ON again. * Make sure NOT to start the car within the next 2 minutes. After that, try starting the engine.

Return to Immobilizer I ECU Swapping.