View source for Readiness - APB Engine Code

=== Defined Test Drive ===

'''<u>Prerequisites:</u>'''
* Ignition ON and Engine ON.
* No Fault Codes stored.
* Transmission Oil Temperature must be between 60 °C and 90 °C.
** If the procedure does not succeed in the first try, make sure the temperature is above 80 °C.
* All driving and braking has to be done in partial load, avoid full throttle/braking!
* Normally the adaptation needs to be carried out when:
** Transmission Control Module has been recoded
** Input Shaft has been replaced
** Hydraulic Unit has been replaced
** Transmission Control Module has been replaced
** Transmission has been replaced


'''[Select]'''<br>
'''[02 - Transmission]'''<br>
'''[Adaptation - 10]'''<br>
Channel 000<br>
'''[Read]'''<br>
'''[Save]'''<br>
'''[Done, Go Back]'''<br>
'''[Measuring Blocks - 08]'''<br>
Block 010 (in 1st Row)<br>
Block 011 (in 2nd Row)<br>
'''[Go!]'''<br>
Check fields 2, specification is '''ADP OK'''.<br>
* Move the selector lever in position '''D''' and drive with partial load '''20 m / 70 ft''' forward, then brake to standstill.
* Hold the brake for 10 seconds.
* Move the selector lever in position '''R''' and drive with partial load '''20 m / 70 ft''' reverse, then brake to standstill.
* Hold the brake for 10 seconds.
The procedure needs to be repeated at least 5 times and can be repeated up to 10 times until the measuring values show '''ADP OK'''.<br>
'''[Done, Go Back]'''<br>
'''[Close Controller, Go Back - 06]'''<br><br>