View source for B2010

__FORCETOC__
=== B2010 - No Basic Setting ===

==== Possible Causes ====

* Basic Setting lost

==== Possible Solutions ====

* Perform Basic Setting
** See Vehicle specific [[Diagnostic Procedures]] for Details

==== Special Notes ====

* When found in the [[VW Touareg (7P) Trunk Electronics]] 6D control module perform the Rear Lid relearn.
* When found in the [[VW Touareg (7P) Parking Brake]] 53 control module review the following forum post:
** https://forums.ross-tech.com/showthread.php?23560
* When found in the BA-Motor Mounts (J931) control module (typically in conjunction with [[B2005]]) on [[Audi A6/S6/RS6/allroad (4G/FC) | 4G Chassis]] S6/S7/RS7 with 4.0T engine see:
** NAR (North American) Market TPI 2036392
** RoW (Rest of World) Market TPI 2036309
*** Those TPIs discuss Audi SVM code BAA001 for the flash update in addition to a mechanical adjustment and Basic Setting procedure. The RoW document includes the S8 model.
* When found in an UDS EPB system, perform Basic Settings Start of operations.
* When found in RoW market UDS protocol 17-Instrument clusters, check the service related Adaptation channels.  This thread should add clarity: https://forums.ross-tech.com/showthread.php?1874-Audi-Q3-fault-code-1048578-No-Basic-Setting

[[Category:Fault Codes]]