View source for 7-Speed Direct Shift Gearbox (DSG/0BH/0BT)

From Ross-Tech Wiki

← 7-Speed Direct Shift Gearbox (DSG/0BH/0BT)

You do not have permission to edit this page, for the following reason:

---

You can view and copy the source of this page.

__FORCETOC__ '''General Information''' about the '''DQ500''' Transmission can be found in the [https://en.wikipedia.org/wiki/Direct-shift_gearbox Wikipedia entry]. Additional information can be found in the [[Official Factory Repair Information]] and sources such as [https://static.nhtsa.gov/odi/tsbs/2016/MC-10130218-9999.pdf SSP (Self-Study Program 950173)] and [https://static.nhtsa.gov/odi/tsbs/2018/MC-10159423-0001.pdf SSP (Self-Study Program 850183)].<br> :''('''DQ500''' = 0BT, 0BH, 0DE, 0GC)'' <br> == Coding == * When replacing this Mechatronic unit, if the old Control Module is still accessible, prior to replacement read/copy it's Coding and Paste it into the New coding line of the replacement Module.''' <br> * If the original Coding is unknown, coding information can sometimes be found in the pop-up balloon within the VCDS '''[[http://www.ross-tech.com/vcds/tour/recode_screen.html Coding-07]]''' function.<br> == Basic Setting == '''<u>Prerequisites:</u>'''<br> * Transmission fluid level is correct and temperature greater than 15°C ''(Do NOT continue if the temp is too low)'' * No fault codes other than '''P175F 00 [047] - Basic Settings Not Performed''' * Advanced Measuring Values = [Control Module temperature] * Selector lever in [P] * Engine at idle speed, do not press accelerator pedal * Parking brake and foot brake applied during the entire procedure<br> '''Important!''' :*''All Prerequisites must be adhered to''<br> :*''The brake pedal '''must''' be depressed during the entire procedure''<br> :*''Not all transmission controllers support this Basic Settings function''<br> === DQ500 - Basic Settings Procedure === '''[Select] - [02 - Transmission]'''<br> :'''[Basic Settings - UDS]'''<br> :Select '''[Basic settings of transmission]''' ''(Do not press [Go!] yet!)'' Select the following '''[Show Measuring Data]''' values: : [Engine speed] : [Main status of abort code basic setting] : [Status of basic setting] : [Status of basic setting data for clutch] : [Status of basic setting data; gear selector] : [Sub-status of abort code basic setting] Then press '''[Go!]''' Display should read '''[Running]''' : Wait for the '''[Finished correctly]''' : Press '''[Done, Go Back]''' : Check for fault codes. : Close controller : '''Important!''' Cycle the ignition '''Off''' and then Back '''On!''' <br> ::''(Failure to complete this last step will result in the inability to select any gear!)'' == Special Notes == * During the basic setting procedure, there maybe some loud gear shifting noises from the transmission, this is normal. * If the Basic Settings fail, please email Ross-Tech with a complete Auto-Scan and the information found in the [Show Measuring Data] at the time of failure. * Basic settings may not complete successfully if: ** The fluid temperature gets too hot. ** Brake is released Additional Information and screen shots can be found on the Ross-Tech forum post ''(Thank you! AdvTechTS)'':<br> :: https://forums.ross-tech.com/index.php?threads/36443/#post-305183 == Replacement == See the [[Official Factory Repair Information]] for the correct procedures. [[Category:Transmissions]]

Return to 7-Speed Direct Shift Gearbox (DSG/0BH/0BT).