View source for Headlight Aim Control Audi (8K) / (8T)

__FORCETOC__
== Coding ==

Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding.


== Adaptation ==
=== Channel 010: Tourist Solution ===
When driving in countries where driving is performed on the opposite side as in the native country the headlights must be changed over to avoid blinding the oncoming traffic.
* 0 = Disabled
* 1 = Enabled


== Security Access ==

Security Access codes will be shown in VCDS while connected to the vehicle.


== Basic Setting ==
=== Headlight Adjustment ===

'''[Select]'''<br>
'''[55 - Xenon Range]'''<br>
'''[Basic Settings - 04]'''<br>
Group 001<br>
'''[Go!]'''<br>
Activate the Basic Setting.<br>
'''[ON/OFF/Next]'''<br>
* The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
* Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
'''[ON/OFF/Next]'''<br>
The adjustment should now be learned.<br>
'''[Done, Go Back]'''<br>
Don't forget to check/clear fault codes afterwards.<br>
'''[Close Controller, Go Back - 06]'''<br>