View source for Immobilizer I Immobilizer Swapping (Separate)

__FORCETOC__
This procedure details how to swap immobilizer control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I.

== Determining IMMO-ID ==

'''[Select]'''<br>
'''[25 - Immobilizer]'''<br>
Look at the first "Extra" field. You should see something like: ''Immo-ID VWZ7Z0W0648696''.<br>
'''[Close Controller, Go Back - 06]'''<br>


== Immobilizer Control Module Swapping ==

'''<u>Prerequisites:</u>'''<br>
* Battery voltage at least 12.0 V.<br>
* Keys matched to Immobilizer Control Module


'''[Select]'''<br>
'''[25 - Immobilizer]'''<br>
'''[Login - 11]'''<br>
* '''4-digit PIN'''
** Enter zero followed by the 4-digit PIN. ''For example, if your PIN is 1234, enter 01234.''
'''[Do it!]'''<br>


'''[Adaptation - 10]'''<br>
Channel 000<br>
'''[Read]'''<br>
'''[Save]'''<br>
'''[Done, Go Back]'''<br>
'''[Close Controller, Go Back - 06]'''<br>

* Switch OFF the ignition and after 5 seconds switch it ON again.
* Make sure NOT to start the car within the next 2 minutes.

After that, [[Immobilizer I Key Matching (Separate)|Match the vehicle Keys]].