View source for VW Transporter (7D) Brake Electronics (Bosch 5.3 ESP)

__FORCETOC__
== Login ==

'''''Note #1''': ''After Login has been carried out you need to recode the control module.''<br>
'''''Note #2''': The Production Codes (PR-Code) such as '''1LX''' can be found on a Sticker near the Spare Tire Well and/or the 1st Page of the Service Manual. <br>Click [http://www.ross-tech.net/vag-com/misc-images/PR-Codes.png here to see an Example of a Sticker].''<br>

'''07669''' is the Login code needed for US Market with (PR-1P4/1LB)

If your vehicle is not a US-market 24V VR6 Eurovan, then please email Support@Ross-Tech.com for additional choices.

== Coding ==

'''''Note #1''': Coding is accepted after a specific login has been carried out.''<br>
'''''Note #2''': After successful coding the steering angle sensor basic setting needs to be carried out.''<br>
'''''Note #3''': The Production Codes (PR-Code) such as '''1LX''' can be found on a Sticker near the Spare Tire Well and/or the 1st Page of the Service Manual. <br>Click [http://www.ross-tech.net/vag-com/misc-images/PR-Codes.png here to see an Example of a Sticker].''<br>

'''''Note #4''': ''You may need to put a non-zero WSC in the Coding screen, anything should work such as 12345.'' <br>

'''06639''' is the Coding value needed for US Market with (PR-1P4/1LB)

If your vehicle is not a US-market 24V VR6 Eurovan, then please email Support@Ross-Tech.com for additional choices.

== Basic Setting ==

=== Steering Angle Sensor (G85) Calibration ===

'''''Note''': ''A successful calibration usually requires a correct coding, so make sure the control module is correctly coded first.''<br>

Turn steering wheel at least 30 ° left and back straight ahead.<br>

'''[Meas. Blocks - 08]'''<br>
Group 005 Field 1 (Steering Angle Sensor -G85-)<br>
Specification: 0.0 °<br>
Tolerance (when straight): ±5.0 °<br>
'''[Done, Go Back]'''<br>

'''[Login - 11]'''<br>
Enter 40168<br>
'''[Do It!]'''<br>

'''[Basic Settings - 04]'''<br>
Group 001<br>
'''[Go!]'''<br>
'''[Done, Go Back]'''<br>

'''[Fault Codes - 02]'''<br>
All fault codes should have disappeared.<br>
'''[Done, Go Back]'''<br>

'''[Close Controller, Go Back - 06]'''<br>

==== Note ====
* After doing the G85 Calibration, you may get a 01486 - System Function Test Active, this is normal.  Please see [[01486]].
* Tech Tip [45-07-19] exist because the factory scan tool apparently forgot how work with Transporters.
** https://static.nhtsa.gov/odi/tsbs/2017/MC-10125590-9999.pdf  NHTSA