02914 - Revision history

Dana at 13:57, 25 June 2018

2018-06-25T13:57:28Z

← Older revision		Revision as of 13:57, 25 June 2018
Line 23:		Line 23:
	* When found in the [[Audi Q5 (8R) \| Audi Q5]] or [[Audi Q7 (4L) \| Audi Q7]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information \| repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches.		* When found in the [[Audi Q5 (8R) \| Audi Q5]] or [[Audi Q7 (4L) \| Audi Q7]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information \| repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches.
	** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal.		** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal.
			* When found in models such as the Audi A1 (8X) or Audi Q3 (8U/FS) with PQ35 BCM, make sure G525 is connected and properly installed. Measuring Block data is discussed [http://forums.ross-tech.com/showthread.php?14694-Wanted-Audi-A1-or-Q3-BCM-(PQ35)-Measuring-Block-Maps&p=132520&viewfull=1#post132520 Here]
	[[Category:Fault Codes]]		[[Category:Fault Codes]]

Dana at 17:06, 18 January 2013

2013-01-18T17:06:38Z

← Older revision		Revision as of 17:06, 18 January 2013
Line 21:		Line 21:
	==== Special Notes ====		==== Special Notes ====

	* When found in the [[Audi Q5 (8R) \| Audi Q5]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information \| repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches.		* When found in the [[Audi Q5 (8R) \| Audi Q5]] or [[Audi Q7 (4L) \| Audi Q7]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information \| repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches.
	** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal.		** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal.

	[[Category:Fault Codes]]		[[Category:Fault Codes]]

Dana: Created page with "FORCETOC == 02914 - Sensor 1 for Trunk/Hatch Closed (G525) == === 02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus === ==== Possible Symptoms ==== ..."

2012-09-12T20:41:51Z

Created page with "__FORCETOC__ == 02914 - Sensor 1 for Trunk/Hatch Closed (G525) == === 02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus === ==== Possible Symptoms ==== ..."

New page

__FORCETOC__
== 02914 - Sensor 1 for Trunk/Hatch Closed (G525) ==

=== 02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus ===

==== Possible Symptoms ====

* Tailgate open warning active on dash
* Rear tailgate lamps not operating

==== Possible Causes ====

* Hatch Closed switch G525 unplugged or faulty
* Power or ground supply issue to Hatch Closed switch G525

==== Possible Solutions ====

* Confirm connection issues are not present
* Test/replace Hatch Closed switch G525

==== Special Notes ====

* When found in the [[Audi Q5 (8R) | Audi Q5]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information | repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches.
** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal.

[[Category:Fault Codes]]

02914 - Revision history

Dana at 13:57, 25 June 2018

Dana at 17:06, 18 January 2013

Dana: Created page with "__FORCETOC__ == 02914 - Sensor 1 for Trunk/Hatch Closed (G525) == === 02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus === ==== Possible Symptoms ==== ..."

Dana: Created page with "FORCETOC == 02914 - Sensor 1 for Trunk/Hatch Closed (G525) == === 02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus === ==== Possible Symptoms ==== ..."