Jef: Created page with "== 721152 - Brake pad replacement mode active == ==== Possible Symptoms ==== * EPB light on ==== Possible Causes ==== * Parking Brakes in service mode for rear brake job *..."

2014-05-09T16:21:42Z

Created page with "== 721152 - Brake pad replacement mode active == ==== Possible Symptoms ==== * EPB light on ==== Possible Causes ==== * Parking Brakes in service mode for rear brake job *..."

New page

== 721152 - Brake pad replacement mode active ==

==== Possible Symptoms ====

* EPB light on

==== Possible Causes ====

* Parking Brakes in service mode for rear brake job
** Basic Settings "Start lining change mode"

==== Possible Solutions ====

* Complete rear brake job, then test parking brake operation

==== Special Notes ====

* On UDS EPB modules, this code is normal while doing rear brake service. In most cases, you can not clear this code out with a scan tool, it should clear out on its own after you set and release the parking brakes.

__FORCETOC__
[[Category:Fault Codes]]

721152 - Revision history

Jef: Created page with "== 721152 - Brake pad replacement mode active == ==== Possible Symptoms ==== * EPB light on ==== Possible Causes ==== * Parking Brakes in service mode for rear brake job *..."