Audi A6 (4F) Parking Brake

Coding

• 000??xx: Engine
  • 01 = 2.0l TDI (Diesel)
  • 03 = 3.0l TDI (Diesel)
  • 05 = 2.7l TDI (Diesel)
  • 10 = 2.0l TFSI (Gasoline)
  • 20 = 2.4l MPI (Gasoline)
  • 30 = 2.8l FSI (Gasoline)
  • 40 = 3.0l MPI (Gasoline)
  • 50 = 3.2l FSI (Gasoline)
  • 60 = 4.2l MPI (Gasoline)
  • 70 = 4.2l FSI (Gasoline)
• 000xx?x: Transmission
  • 1 = Manual Transmission
  • 2 = Automatic Transmission (09L/09E)
  • 3 = Multitronic (01J)
• 000xxx?: Country
  • 1 = Rest of World (RoW)
  • 2 = USA/Canada
  • 3 = Japan
    
    

Basic Setting

Open Rear Parking Brake

Cycle the Parking Brake ON, then OFF first.

[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 007
[Go!]
The brake calipers will then open, allowing the pads to be changed.
[Done, Go Back]
[Close Controller, Go Back - 06]
It is normal for the LED in the parking brake switch and the warning lamp in the instrument cluster to blink rapidly at this point.

---

Close Rear Parking Brake

[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 006
[Go!]
The brake calipers will then close.
[Done, Go Back]
[Close Controller, Go Back - 06]
The LED in the parking brake switch and the warning lamp in the instrument cluster will probably continue to blink rapidly. This should stop after cycling the Parking Brake ON, then OFF again.

---

Function Test

[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 010
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The brake pads will then now opening and close 3 times.
[Done, Go Back]
[Close Controller, Go Back - 06]

Special Procedures

• Parking Brake Pad Replacement