Difference between revisions of "00515"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
RtWiKiSyS0p (talk | contribs) m |
||
| Line 20: | Line 20: | ||
| − | === 00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to | + | === 00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to Plus === |
==== Possible Causes ==== | ==== Possible Causes ==== | ||
| Line 35: | Line 35: | ||
* Check Camshaft Timing | * Check Camshaft Timing | ||
* Check/Replace Engine Control Module | * Check/Replace Engine Control Module | ||
| + | |||
| + | |||
| + | === 00515 - Camshaft Position (Hall) Sensor (G40): Short to Ground === | ||
| + | |||
| + | ==== Possible Symptoms ==== | ||
| + | |||
| + | * Power Loss | ||
| + | * Emissions not OK | ||
| + | * High Fuel Consumption | ||
| + | |||
| + | ==== Possible Causes ==== | ||
| + | |||
| + | * Wiring to Camshaft Position (Hall) Sensor (G40) faulty | ||
| + | * Camshaft Position (Hall) Sensor (G40) faulty | ||
| + | |||
| + | ==== Possible Solutions ==== | ||
| + | |||
| + | * Check Wiring to Camshaft Position (Hall) Sensor (G40) | ||
| + | * Check/Replace Camshaft Position (Hall) Sensor (G40) | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 08:50, 13 February 2007
00515 - Camshaft Position (Hall) Sensor (G40)
00515 - Camshaft Position (Hall) Sensor (G40): No Signal
Possible Causes
- Wiring to Camshaft Position (Hall) Sensor (G40) faulty
- Camshaft Position (Hall) Sensor (G40) faulty
Possible Solutions
- Check Wiring to Camshaft Position (Hall) Sensor (G40)
- Check/Replace Camshaft Position (Hall) Sensor (G40)
- Check/Replace Engine Control Module
Special Notes
- Some older engines store this code as long as the engine is not running, if in doubt read fault codes with the engine running again.
00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to Plus
Possible Causes
- Wiring to Camshaft Position (Hall) Sensor (G40) faulty
- Camshaft Position (Hall) Sensor (G40) Installation faulty
- Camshaft Timing Out of Specification
- Camshaft Position (Hall) Sensor (G40) faulty
Possible Solutions
- Check Wiring to Camshaft Position (Hall) Sensor (G40)
- Check/Replace Camshaft Position (Hall) Sensor (G40)
- Check Camshaft Timing
- Check/Replace Engine Control Module
00515 - Camshaft Position (Hall) Sensor (G40): Short to Ground
Possible Symptoms
- Power Loss
- Emissions not OK
- High Fuel Consumption
Possible Causes
- Wiring to Camshaft Position (Hall) Sensor (G40) faulty
- Camshaft Position (Hall) Sensor (G40) faulty
Possible Solutions
- Check Wiring to Camshaft Position (Hall) Sensor (G40)
- Check/Replace Camshaft Position (Hall) Sensor (G40)