Difference between revisions of "01487"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) (New page: __FORCETOC__ == 01487 - System Function Test == === 01487 - System Function Test: Implausible Signal === ==== Possible Symptoms ==== * Malfunction Indicator Light (MIL) ON ==== Possibl...) |
RtWiKiSyS0p (talk | contribs) m |
||
| Line 15: | Line 15: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * When found in [[Audi A8 (4E)], this Fault Code can have several different Reasons but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197). | + | * When found in [[Audi A8 (4E)]], this Fault Code can have several different Reasons but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197). |
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 05:01, 22 May 2009
01487 - System Function Test
01487 - System Function Test: Implausible Signal
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
Possible Causes
- Internal Error in Control Module for Level Control (J197)
- Control Module for Level Control (J197) faulty
Special Notes
- When found in Audi A8 (4E), this Fault Code can have several different Reasons but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197).