Difference between revisions of "19143/P2711/010001"

Revision as of 07:29, 29 June 2010

Check Output Shaft Speed Sensor 1/2 (G501/G502)
- Check Measuring Value Blocks (MVB)
Check/Replace Mechatronic Unit for Double Clutch Transmission (J743)

When found in 6-Speed Direct Shift Gearbox (DSG/02E), check Measuring Value Block (MVB) 008. The Output Shaft Speeds should align with the Input Shaft Speed during a Test Drive (Tiptronic in Gear 1/2) with the Clutch engaged.

@@ Line 1: / Line 1: @@
-__FORCETOC__
 == 19143/P2711/010001 - Unexpected / Implausible Mechanical Gear Disengagement ==
+=== 19143/P2711/010001 - Unexpected / Implausible Mechanical Gear Disengagement: No Signal/Communication ===
+==== Possible Symptoms ====
+* Malfunction Indicator Light (MIL) ON
+* Transmission Malfunction
+* Erratic Driving Behavior
+==== Possible Causes ====
+* Output Shaft Speed Sensor 1/2 (G501/G502) faulty
+* Mechatronic Unit for Double Clutch Transmission (J743) faulty
+==== Possible Solutions ====
+* Check Output Shaft Speed Sensor 1/2 (G501/G502)
+** Check Measuring Value Blocks (MVB)
+* Check/Replace Mechatronic Unit for Double Clutch Transmission (J743)
+==== Special Notes ====
+* When found in [[6-Speed Direct Shift Gearbox (DSG/02E)]], check Measuring Value Block (MVB) 008. The Output Shaft Speeds should align with the Input Shaft Speed during a Test Drive (Tiptronic in Gear 1/2) with the Clutch engaged.
 === 19143/P2711/010001 - Unexpected / Implausible Mechanical Gear Disengagement: No or Incorrect Basic Setting / Adaptation ===
@@ Line 8: / Line 31: @@
 * When found in [[6-Speed Direct Shift Gearbox (DSG/02E)]], perform [[6-Speed Direct Shift Gearbox (DSG/02E)#Basic Setting|Basic Setting]].<br>
+__FORCETOC__
 [[Category:Fault Codes]]