Difference between revisions of "P320C/012812"
From Ross-Tech Wiki
(Created page with "== P320C/012812 - Oxygen (Lambda) Sensor B1 S1/S2: Lean Correlation == ==== Possible Causes ==== * Exhaust Leak before O2 Sensor * False air leak in the intake system after ...") |
|||
| Line 15: | Line 15: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | |||
| − | |||
* When found in NAR 2009 - 2010 Volkswagen Jetta with a 2.0L TDI CBEA or CJAA please see TSB 23 11 01 | * When found in NAR 2009 - 2010 Volkswagen Jetta with a 2.0L TDI CBEA or CJAA please see TSB 23 11 01 | ||
Revision as of 13:27, 17 April 2015
P320C/012812 - Oxygen (Lambda) Sensor B1 S1/S2: Lean Correlation
Possible Causes
- Exhaust Leak before O2 Sensor
- False air leak in the intake system after the MAF sensor
- Failed O2 Sensors
Possible Solutions
- Repair exhaust Leak before O2 Sensor
- Repair false air leak in the intake system after the MAF sensor
- Replace failed O2 Sensors
- Reset O2 Sensor adapted values, see notes below
Special Notes
- When found in NAR 2009 - 2010 Volkswagen Jetta with a 2.0L TDI CBEA or CJAA please see TSB 23 11 01
- A new software version is available.
- Check Measuring Value Blocks (CBEA/CJAA) Group 041-(B1S1) and 136-(B1S2) for O2 Sensor adapted values
- Normal Range is [-1.28 to 1.22] - if out of range suspect failed O2 Sensors
- To reset the above value after a repair, disconnect the O2 sensors, cycle the ignition on/off for 5 seconds and reconnect O2 sensors, clear codes and check MVB data again.
- Normal Range is [-1.28 to 1.22] - if out of range suspect failed O2 Sensors