Difference between revisions of "User talk:Jef"
| Line 20: | Line 20: | ||
** IDE03873-ENG99733,Seat occupied recognition compensated imaginary part-Measured Value Capacitance | ** IDE03873-ENG99733,Seat occupied recognition compensated imaginary part-Measured Value Capacitance | ||
*** Not all systems have location IDE03873-ENG99733 | *** Not all systems have location IDE03873-ENG99733 | ||
| − | It can be normal for one of those locations to be a value of 0 pF, but if two of those locations are 0 pF, it can be a sign of a failed pressure mat that needs to be replaced. | + | It can be normal for one of those locations to be a value of 0 pF, but if two of those locations are 0 pF, it can be a sign of a failed pressure mat that needs to be replaced. We would appreciate feedback on this if possible. |
* We had a repair facility report a Battery Disconnect was required when matching a brand new PODS module to the original Airbag controller when working on a 2011 Jetta Sedan. | * We had a repair facility report a Battery Disconnect was required when matching a brand new PODS module to the original Airbag controller when working on a 2011 Jetta Sedan. | ||
Revision as of 13:31, 5 April 2023
[Select]
[15 - Airbags]
[Security Access - 16]
Enter the code shown in the pop-up balloon to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Select Resetting seat occupied recognition.
When applicable type the single digit 0 into the (reserved) box. If this is not present skip this step.
[Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]
The reset has been performed.
[Done, Go Back]
[Fault Codes - 02] Faults should NOT be stored
[Close Controller, Go Back - 06]
Notes
- If you get a "Request Sequence Error" when performing the Resetting seat occupied recognition then check the following Advance Measuring Values:
- IDE03871-ENG99733,Seat occupied recognition real part-Measured Value Capacitance
- IDE03872-ENG99733,Seat occupied recognition imaginary part-Measured Value Capacitance
- IDE03873-ENG99733,Seat occupied recognition compensated imaginary part-Measured Value Capacitance
- Not all systems have location IDE03873-ENG99733
It can be normal for one of those locations to be a value of 0 pF, but if two of those locations are 0 pF, it can be a sign of a failed pressure mat that needs to be replaced. We would appreciate feedback on this if possible.
- We had a repair facility report a Battery Disconnect was required when matching a brand new PODS module to the original Airbag controller when working on a 2011 Jetta Sedan.