|
|
| (16 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| | + | = WARNING: RESTRICTED ACCESS = |
| | | | |
| | + | Your attempt to access this page is considered UNAUTHORIZED! |
| | + | '''ERROR 401: UNAUTHORIZED''' |
| | | | |
| − | == Audi A5 (8T) Active/Dynamic Steering ==
| + | Your IP address has been logged. |
| − | | |
| − | | |
| − | === 1B-Active Steering ===
| |
| − | | |
| − | | |
| − | '''<u>Prerequisites:</u>'''<br>
| |
| − | * Battery Voltage = 12.0 - 14.0 V'''<br>
| |
| − | * No fault codes other than [[01087 | 01087 - Basic Setting Not Performed]]'''<br>
| |
| − | | |
| − | * Perform G85-Steering Angle Sensor Basic Settings found on this Ross-Tech wiki page: [[Audi A5 (8T) Steering Wheel Electronics#Basic Setting|Audi A4/A5 (8K/8T) Steering Angle Sensor (G85) Calibration]]
| |
| − | | |
| − | | |
| − |
| |
| − | | |
| − | | |
| − | <span style="color:#000000; background:#FFFF00"> '''- Continue Only after successfully completing the G85 basic settings -''' </span>
| |
| − | | |
| − | *Leave the steering wheel in the straight ahead position during the next steps.
| |
| − | | |
| − | | |
| − | '''[Select]'''<br>
| |
| − | '''[1B-Active Steering]'''<br>
| |
| − | | |
| − | '''[Security Access - 16]'''<br>
| |
| − | Enter 61378, to enable the basic setting.'''<br>
| |
| − | '''[Do it!]'''<br>
| |
| − | | |
| − | | |
| − | '''[Basic Settings - 04]'''<br>
| |
| − | Group 101<br>
| |
| − | '''[Go!]'''<br>
| |
| − | '''[ON/OFF/Next]''' <br>
| |
| − | | |
| − | * The results should be stored after a key cycle and fault code(s) should clear.
| |
| − | | |
| − | | |
| − | '''[Done, Go Back]''' <br>
| |
| − | '''[Fault Codes - 02]'''<br>
| |
| − | Check and clear fault codes.<br>
| |
| − | '''[Close Controller, Go Back - 06]'''<br>
| |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | ======================================================================
| |
| − | | |
| − | | |
| − | | |
| − | 000 No Read out - Fault Not Stored <br>
| |
| − | 001 Upper limit surpassed <br>
| |
| − | 002 Short time fault <br>
| |
| − | 003 Mechanical Fault <br>
| |
| − | 004 No signal/Communication <br>
| |
| − | 005 No or Incorrect Basic Settings - Adaption <br>
| |
| − | 006 Short circuit to Positive <br>
| |
| − | 007 Short circuit to Ground <br>
| |
| − | 008 Implausible Signal <br>
| |
| − | 009 <br>
| |
| − | 010 <br>
| |
| − | 011 Open Circuit <br>
| |
| − | 012 Electrical Fault in Circuit <br>
| |
| − | 013 Please check fault memory <br>
| |
| − | 014 Defective <br>
| |
| − | 015 <br>
| |
| − | 016 <br>
| |
| − | 017 <br>
| |
| − | 018 <br>
| |
| − | 019 <br>
| |
| − | 020 <br>
| |
| − | <br>
| |
| − | | |
| − | 000 Fault Not Stored <br>
| |
| − | 001 Sporadic Fault <br>
| |
| − | 002 Short time fault <br>
| |
| − | 003 <br>
| |
| − | 002 Lower Limit not achieved <br>
| |