Difference between revisions of "03409"
From Ross-Tech Wiki
(Created page with "__FORCETOC__ == 03409 - Rolling Mode Recognized == == Possible Symptoms == * DTC stored in ABS * MIL/Warning lamps may illuminate * No actual drivability complaint in most c...") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 3: | Line 3: | ||
== 03409 - Rolling Mode Recognized == | == 03409 - Rolling Mode Recognized == | ||
| − | == Possible Symptoms == | + | ==== Possible Symptoms ==== |
* DTC stored in ABS | * DTC stored in ABS | ||
* MIL/Warning lamps may illuminate | * MIL/Warning lamps may illuminate | ||
* No actual drivability complaint in most cases | * No actual drivability complaint in most cases | ||
| − | == Possible Causes == | + | ==== Possible Causes ==== |
* Vehicle operated on a chassis dynamometer (rolling road) | * Vehicle operated on a chassis dynamometer (rolling road) | ||
* Front or drive wheels spinning while vehicle is on a lift | * Front or drive wheels spinning while vehicle is on a lift | ||
* Mismatch between wheel speed signals and vehicle operating conditions | * Mismatch between wheel speed signals and vehicle operating conditions | ||
| − | == Possible Solutions == | + | ==== Possible Solutions ==== |
* Clear DTC after completing work on a chassis dynamometer | * Clear DTC after completing work on a chassis dynamometer | ||
* Cycle ignition OFF → wait ~10 seconds → ON, then clear codes | * Cycle ignition OFF → wait ~10 seconds → ON, then clear codes | ||
| Line 19: | Line 19: | ||
* No component replacement is required unless additional faults are present | * No component replacement is required unless additional faults are present | ||
| − | == Special Notes == | + | ==== Special Notes ==== |
| − | * According to the | + | * According to the manufacturer: ''The malfunction will be automatically erased if, after completing work on the roller chassis dynamometer, the ignition has been switched off and on again.'' |
* It is possible to set this code when the vehicle is on a service lift, in gear and the drive wheels are spinning. | * It is possible to set this code when the vehicle is on a service lift, in gear and the drive wheels are spinning. | ||
* If the DTC recurs under normal road use, investigate wheel speed sensors and ABS system further. | * If the DTC recurs under normal road use, investigate wheel speed sensors and ABS system further. | ||
Latest revision as of 18:53, 18 September 2025
03409 - Rolling Mode Recognized
Possible Symptoms
- DTC stored in ABS
- MIL/Warning lamps may illuminate
- No actual drivability complaint in most cases
Possible Causes
- Vehicle operated on a chassis dynamometer (rolling road)
- Front or drive wheels spinning while vehicle is on a lift
- Mismatch between wheel speed signals and vehicle operating conditions
Possible Solutions
- Clear DTC after completing work on a chassis dynamometer
- Cycle ignition OFF → wait ~10 seconds → ON, then clear codes
- Ensure vehicle is operated on approved test equipment when simulating road load
- No component replacement is required unless additional faults are present
Special Notes
- According to the manufacturer: The malfunction will be automatically erased if, after completing work on the roller chassis dynamometer, the ignition has been switched off and on again.
- It is possible to set this code when the vehicle is on a service lift, in gear and the drive wheels are spinning.
- If the DTC recurs under normal road use, investigate wheel speed sensors and ABS system further.