Difference between revisions of "VW Sharan (7M) Brake Electronics (MK25)"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m (typo) |
|||
| (2 intermediate revisions by one other user not shown) | |||
| Line 3: | Line 3: | ||
== Coding == | == Coding == | ||
| − | '' | + | * '''ABS''' |
| − | '' | + | ** 07177 = Standard |
| + | * '''ABS/EDS/ASR/ESP''' | ||
| + | ** 06154 = Front-Wheel-Drive (FWD) | ||
| + | ** 06667 = All-Wheel-Drive (AWD) | ||
| + | |||
| + | |||
== Basic Setting == | == Basic Setting == | ||
| Line 31: | Line 36: | ||
After a successful basic setting, field 2 should say "OK".<br> | After a successful basic setting, field 2 should say "OK".<br> | ||
'''[Done, Go Back]'''<br> | '''[Done, Go Back]'''<br> | ||
| − | To make sure the basic setting was | + | To make sure the basic setting was successful, check the sensor again.<br> |
'''[Measuring Blocks - 08]'''<br> | '''[Measuring Blocks - 08]'''<br> | ||
Group 004<br> | Group 004<br> | ||
Latest revision as of 21:33, 14 December 2014
Coding
- ABS
- 07177 = Standard
- ABS/EDS/ASR/ESP
- 06154 = Front-Wheel-Drive (FWD)
- 06667 = All-Wheel-Drive (AWD)
Basic Setting
Sensor for Steering Angle (G85)
Prerequisites:
- Start the vehicle.
- Turn the steering wheel one turn to the right and one turn to the left (at least ± 15 ° each side).
- Drive in a short distance straight line on a level surface at a speed not higher than 20 km/h.
- If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight.
- Ensure that the steering wheel is not moved again.
- Keep the engine running and do not switch off the ignition.
- System voltage at least 12.0 V.
[Select]
[03 - Brake Electronics]
[Coding-II - 11]
Enter 40168, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 060
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
After a successful basic setting, field 2 should say "OK".
[Done, Go Back]
To make sure the basic setting was successful, check the sensor again.
[Measuring Blocks - 08]
Group 004
[Go!]
Check field 1, the value has to be between -1.5 and +1.5 °.
[Done, Go Back]
[Close Controller, Go Back - 06]