Difference between revisions of "18261/P1853/006227"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
RtWiKiSyS0p (talk | contribs) m |
||
| (One intermediate revision by the same user not shown) | |||
| Line 13: | Line 13: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * When found in [[6-Speed Direct Shift Gearbox (DSG/02E)]], perform [[6-Speed Direct Shift Gearbox (DSG/02E)#Reset Values (ESP & Tip Cruise Control Installation)|Reset ESP & Tip Cruise Control Installation]] | + | * When found in [[6-Speed Direct Shift Gearbox (DSG/02E)]], perform [[6-Speed Direct Shift Gearbox (DSG/02E)#Reset Values (ESP & Tip Cruise Control Installation)|Reset ESP & Tip Cruise Control Installation]]. |
| − | ** | + | ** Control Modules usually store a list of their Communication Partners, if this List changes (e.g. due to Replacements or Updates) the Transmission Control Module may store this Fault Code. |
| + | ** '''[Select]''' | ||
| + | ** '''[02 - Transmission]''' | ||
| + | ** '''[Basic Settings - 04]''' | ||
| + | ** Group 069 | ||
| + | ** '''[Go!]''' | ||
| + | ** Activate the Basic Setting. | ||
| + | **'''[ON/OFF/Next]''' | ||
| + | **'''[Done, Go Back]''' | ||
| + | ** '''[Close Controller, Go Back - 06]''' | ||
| + | ** Switch off Ignition, wait 10 Seconds and switch it back on and check for fault codes again. | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 11:03, 31 March 2007
18261/P1853/006227 - Powertrain Data Bus: Implausible Message from ABS Controller
Possible Causes
- CAN-Databus related Wiring/Connectors faulty
Possible Solutions
- Check Measuring Value Blocks (MVB) 125+ for plausibility
- Check Wiring/Connectors from/to ABS Control Module (J104)
Special Notes
- When found in 6-Speed Direct Shift Gearbox (DSG/02E), perform Reset ESP & Tip Cruise Control Installation.
- Control Modules usually store a list of their Communication Partners, if this List changes (e.g. due to Replacements or Updates) the Transmission Control Module may store this Fault Code.
- [Select]
- [02 - Transmission]
- [Basic Settings - 04]
- Group 069
- [Go!]
- Activate the Basic Setting.
- [ON/OFF/Next]
- [Done, Go Back]
- [Close Controller, Go Back - 06]
- Switch off Ignition, wait 10 Seconds and switch it back on and check for fault codes again.