Difference between revisions of "16716/P0332"
From Ross-Tech Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 21: | Line 21: | ||
* Torque Knock Sensor 2 (G66) to specifications | * Torque Knock Sensor 2 (G66) to specifications | ||
* Check wiring and connections | * Check wiring and connections | ||
| − | * Check Knock Sensor 2 ( | + | * Check Knock Sensor 2 (G66) and Knock Control |
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * | + | * The Knock sensor (piezoelectric sensor) is used to detect abnormal combustion events. Voltage (typically 0-5mV) is generated when the Knock sensor ‘hears/feels’ a range of vibrations. If the voltage is not as expected or is out of range this DTC is usually set. |
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 09:04, 23 July 2014
16716/P0332 - Knock Sensor 2 (G66): Signal Too Low
Possible Symptoms
- Irregular rpm
- Drivability problems
- Loss of power
- Engine damage
Possible Causes
- Circuit G66 short to Ground
- Circuit G66 open
- G66 improperly torqued
- G66 damaged
- Control Module damaged
Possible Solutions
- Torque Knock Sensor 2 (G66) to specifications
- Check wiring and connections
- Check Knock Sensor 2 (G66) and Knock Control
Special Notes
- The Knock sensor (piezoelectric sensor) is used to detect abnormal combustion events. Voltage (typically 0-5mV) is generated when the Knock sensor ‘hears/feels’ a range of vibrations. If the voltage is not as expected or is out of range this DTC is usually set.