Difference between revisions of "18039/P1631"
From Ross-Tech Wiki
(Created page with '== 18039/P1631 - Accelerator Position Sensor (G79): Signal too High == ==== Possible Symptoms ==== * Malfunction Indicator Light (MIL) ON * Reduced Engine Output ==== Possibl…') |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 8: | Line 8: | ||
==== Possible Causes ==== | ==== Possible Causes ==== | ||
| − | * Wiring | + | * Wiring and/or connections faulty |
* Faulty ECM | * Faulty ECM | ||
* Faulty Accelerator Pedal | * Faulty Accelerator Pedal | ||
| Line 16: | Line 16: | ||
* Check Measuring Block Readings for Accelerator Pedal | * Check Measuring Block Readings for Accelerator Pedal | ||
* Check Voltage Signals from ECM to Throttle Pedal (see factory repair manual) | * Check Voltage Signals from ECM to Throttle Pedal (see factory repair manual) | ||
| − | * Check Wiring and Connectors from | + | * Check Wiring and Connectors from ECM to Accelerator Pedal |
| − | |||
| − | |||
| + | ==== Special Notes ==== | ||
| − | + | * There are 2 sensors in the accelerator pedal, both measure the same except that they are working in opposite directions. This means one counts from 0 to 100, while the other one counts from 100 to 0. | |
* Accelerator Position Sensor faults can be caused by issues with the Oxygen Sensor(s) and it's wiring. Please verify this '''BEFORE''' replacing the ECM or Accelerator Pedal. Accelerator Pedal failure is very rare. | * Accelerator Position Sensor faults can be caused by issues with the Oxygen Sensor(s) and it's wiring. Please verify this '''BEFORE''' replacing the ECM or Accelerator Pedal. Accelerator Pedal failure is very rare. | ||
Latest revision as of 11:17, 25 February 2011
18039/P1631 - Accelerator Position Sensor (G79): Signal too High
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
- Reduced Engine Output
Possible Causes
- Wiring and/or connections faulty
- Faulty ECM
- Faulty Accelerator Pedal
Possible Solutions
- Check Measuring Block Readings for Accelerator Pedal
- Check Voltage Signals from ECM to Throttle Pedal (see factory repair manual)
- Check Wiring and Connectors from ECM to Accelerator Pedal
Special Notes
- There are 2 sensors in the accelerator pedal, both measure the same except that they are working in opposite directions. This means one counts from 0 to 100, while the other one counts from 100 to 0.
- Accelerator Position Sensor faults can be caused by issues with the Oxygen Sensor(s) and it's wiring. Please verify this BEFORE replacing the ECM or Accelerator Pedal. Accelerator Pedal failure is very rare.