Difference between revisions of "01128"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 17: | Line 17: | ||
* Check/Replace Immobilizer Pickup Coil (D2) | * Check/Replace Immobilizer Pickup Coil (D2) | ||
** Check Measuring Value Blocks (MVB) | ** Check Measuring Value Blocks (MVB) | ||
| − | * | + | |
| + | ==== Special Notes ==== | ||
| + | |||
| + | * Pickup Coils for Immobilizer 2 and 3 Systems should read ~ 18 to 24 Ω | ||
__FORCETOC__ | __FORCETOC__ | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 10:37, 31 October 2016
01128 - Immobilizer Pickup Coil (D2)
Possible Symptoms
- Immobilizer Warning Light flashing
- Immobilizer active (Engine shuts OFF after 2-3 Seconds)
Possible Causes
- Wiring and/or Connector(s) from/to Immobilizer Pickup Coil (D2) faulty
- Immobilizer Pickup Coil (D2) faulty
- Immobilzier Control Module faulty
Possible Solutions
- Check Wiring and/or Connector(s) from/to Immobilizer Pickup Coil (D2)
- Check/Replace Immobilizer Pickup Coil (D2)
- Check Measuring Value Blocks (MVB)
Special Notes
- Pickup Coils for Immobilizer 2 and 3 Systems should read ~ 18 to 24 Ω