Difference between revisions of "01826"

Latest revision as of 17:33, 18 December 2024

Perform Steering Angle Sensor (G85) Adaptation
- See Vehicle specific Diagnostic Procedures for Details
Check/Replace Steering Angle Sensor (G85)
Check/Replace Steering Column Control Module (J527)

When found in Audi A4/S4/RS4/Cabriolet (8E/8H): Brake Electronics, these are the most likely causes if the Basic Setting fails or the Fault comes back shortly after clearing. See TPI 0984403 for further details.
- MY 2001: Steering Column Control Module (J527) was the most common fault
- MY 2002: Steering Angle Sensor (G85) was the most common fault
- MY 2003/2004: Experience has shown the Steering Angle Sensor (G85) were the only cause, Steering Column Control Module (J527) were not defective yet.
- MY 2006/2007: Steering Column Control Module (J527) was the most common fault
In many cases this code can be cleared out by a simple test drive
- Several lock to lock turns (figure 8 turns) in a safe area
- Short road test, 0.5km
- Do the simple test drive 2 times in a row, then verify DTC is cleared out.

@@ Line 26: / Line 26: @@
 ** MY 2003/2004: Experience has shown the Steering Angle Sensor (G85) were the only cause, Steering Column Control Module (J527) were not defective yet.
 ** MY 2006/2007: Steering Column Control Module (J527) was the most common fault
+* In many cases this code can be cleared out by a simple test drive
+** Several lock to lock turns (figure 8 turns) in a safe area
+** Short road test, 0.5km
+** Do the simple test drive 2 times in a row, then verify DTC is cleared out.
 [[Category:Fault Codes]]