|
|
| (20 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| | + | = WARNING: RESTRICTED ACCESS = |
| | | | |
| | + | Your attempt to access this page is considered UNAUTHORIZED! |
| | + | '''ERROR 401: UNAUTHORIZED''' |
| | | | |
| − | == Basic Settings of the Active/Dynamic Steering ==
| + | Your IP address has been logged. |
| − | | |
| − | | |
| − | === 1B-Active Steering ===
| |
| − | | |
| − | | |
| − | '''<u>Prerequisites:</u>'''<br>
| |
| − | * Battery Voltage = 12.0 - 14.0 V'''<br>
| |
| − | * No fault codes other than [[01087 | 01087 - Basic Setting Not Performed]]'''<br>
| |
| − | * Vehicle is lifted off the ground, on a suitable vehicle lift'''<br>
| |
| − | | |
| − | * Perform G85-Steering Angle Sensor Basic Settings found on this Ross-Tech wiki page:
| |
| − | | |
| − | http://wiki.ross-tech.com/wiki/index.php/Audi_A5_%288T%29_Steering_Wheel_Electronics#Basic_Setting
| |
| − | | |
| − | | |
| − |
| |
| − | '''- Continue only after successfully completing the G85 basic settings:'''
| |
| − |
| |
| − | | |
| − | '''[Select]'''<br>
| |
| − | '''[1B-Active Steering]'''<br>
| |
| − | | |
| − | '''[Security Access - 16]'''<br>
| |
| − | Enter 61378, to enable the basic setting.'''<br>
| |
| − | '''[Do it!]'''<br>
| |
| − | | |
| − | | |
| − | '''[Basic Settings - 04]'''<br>
| |
| − | Group 101<br>
| |
| − | '''[Go!]'''<br>
| |
| − | '''[ON/OFF/Next]''' <br>
| |
| − | | |
| − | * The results should be stored after a key cycle and fault code(s) should clear.
| |
| − | | |
| − | | |
| − | '''[Done, Go Back]''' <br>
| |
| − | '''[Fault Codes - 02]'''<br>
| |
| − | Check and clear fault codes.<br>
| |
| − | '''[Close Controller, Go Back - 06]'''<br>
| |