Difference between revisions of "Immobilizer IV Key Matching"
RtWiKiSyS0p (talk | contribs) m |
|||
Line 66: | Line 66: | ||
**''Switch ignition off and remove key.''<br> | **''Switch ignition off and remove key.''<br> | ||
**''Insert next key to ignition and switch ignition on again.''<br> | **''Insert next key to ignition and switch ignition on again.''<br> | ||
− | **''The warning light for the Immobilizer will light up for ~2 seconds, then go out | + | **''The warning light for the Immobilizer will light up for ~2 seconds, then go out.''<br> |
'''Note:''' ''The above steps after saving the adaptation, should not exceed 60 seconds!'' | '''Note:''' ''The above steps after saving the adaptation, should not exceed 60 seconds!'' |
Revision as of 03:59, 16 June 2011
This procedure details how to match new keys to VW/Audi/Seat/Skoda vehicles with Immobilizer IV.
Determining IMMO-ID & VIN
[Select]
[25 - Immobilizer]
[Meas. Blocks - 08]
Select Block 081.
[Go!]
The first 17-digit string is the VIN. The second 14-digit string in the Immo-ID..
[Done, Go Back]
[Close Controller, Go Back - 06]
Key Matching
Prerequisites:
- All keys are either new or were adapted to this car (IMMO-ID) before.
- You can match up to 8 keys.
- While adapting each key, make sure to place the other keys away from the ignition lock (reader coil). The passenger seat is an adequate place.
- Battery voltage at least 12.0 V.
[Select]
[25 - Immobilizer]
[Meas. Blocks - 08]
Select Block 001.
[Go!]
The value in field 3 must be Yes. If value is No, the key is not capable of being adapted to Immobilizer.
You can check each key in this manner.
Select Block 003.
[Go!]
Make sure the shown lock times in field 1, 2 and 3 are 0 (each field represents a time in minutes).
- If the lock times are NOT 0:
- Do NOT switch off the ignition!
- Allow the car to sit for AT LEAST the number of minutes that were indicated by the fields 1-3.
[Done, Go Back]
[Security Access - 16]
There are 2 possibilities how to enter a PIN, choose the one that applies for you.
- 4-digit PIN
- Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.
- 7-digit PIN
- [Use 7-digit PIN/SKC]
- Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
- [OK]
- VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".
[Do it!]
[Adaptation - 10]
Enter 001 in "Channel Number".
[Read]
The "Stored Value" is the number of keys currently matched.
Enter a "new value" corresponding to the total number of keys to be matched, including any existing keys.
The old keys are automatically beeing cleared.
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
- Repeat the following steps until all keys have been matched:
- Switch ignition off and remove key.
- Insert next key to ignition and switch ignition on again.
- The warning light for the Immobilizer will light up for ~2 seconds, then go out.
- Switch ignition off and remove key.
Note: The above steps after saving the adaptation, should not exceed 60 seconds!