18010/P1602/005634: Difference between revisions
From Ross-Tech Wiki
Table Of Contents
RtWiKiSyS0p (talk | contribs) m 18010/P1602 moved to 18010/P1602/005634 |
RtWiKiSyS0p (talk | contribs) mNo edit summary |
||
| Line 1: | Line 1: | ||
__FORCETOC__ | __FORCETOC__ | ||
== 18010/P1602 - Power Supply B+ Terminal 30: Voltage too Low == | == 18010/P1602/005634 - Power Supply B+ Terminal 30: Voltage too Low == | ||
==== Possible Causes ==== | ==== Possible Causes ==== | ||
* Cables on the | * Cables on the Battery were removed | ||
* Battery weak (voltage) | * Battery weak (voltage) | ||
* Generator | * Generator Disfunction | ||
==== Possible Solutions ==== | ==== Possible Solutions ==== | ||
* Check | * Check Battery Cables | ||
* Check / Replace | * Check/Replace Battery | ||
* Check / Replace | * Check/Replace Generator | ||
==== Special Notes ==== | |||
* If multiple Control Module have Power Supply Faults stored, it's most likely to be one common Problem like the ones shown above. Otherwise when only one or two Control Modules have such Codes stored you better start searching at the individual Power Supply of these Modules. | |||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 14:18, 13 February 2007
18010/P1602/005634 - Power Supply B+ Terminal 30: Voltage too Low
Possible Causes
- Cables on the Battery were removed
- Battery weak (voltage)
- Generator Disfunction
Possible Solutions
- Check Battery Cables
- Check/Replace Battery
- Check/Replace Generator
Special Notes
- If multiple Control Module have Power Supply Faults stored, it's most likely to be one common Problem like the ones shown above. Otherwise when only one or two Control Modules have such Codes stored you better start searching at the individual Power Supply of these Modules.