02844: Difference between revisions

mNo edit summary
mNo edit summary
Line 10: Line 10:
==== Possible Causes ====
==== Possible Causes ====


* Control Module incorrectly coded, Auto-Hold not installed
* Wiring/Connectors from/to Brake Light Switch (F) faulty
* Wiring/Connectors from/to Lamp for Auto-Hold (K237) faulty
* Wiring/Connectors from/to Lamp for Auto-Hold (K237) faulty
* Control Module incorrectly coded
** Auto-Hold not installed
* Wiring/Connectors from/to Brake Light Switch (F) faulty


==== Possible Solutions ====
==== Possible Solutions ====


* Check Wiring/Connectors from/to Lamp for Auto-Hold (K237)
* Perform Output Test
* Check Control Module Coding
* Check Control Module Coding
* Check Wiring/Connectors from/to Brake Light Switch (F)
* Check Wiring/Connectors from/to Brake Light Switch (F)
* Check Wiring/Connectors from/to Lamp for Auto-Hold (K237)


==== Special Notes ====
==== Special Notes ====
Line 26: Line 26:
** Check if Auto-Hold is installed, car data plate ''(sticker on 1st page of the service manual or identical sticker in the trunk)'' should have a '''UH2''' tag.
** Check if Auto-Hold is installed, car data plate ''(sticker on 1st page of the service manual or identical sticker in the trunk)'' should have a '''UH2''' tag.
*** Check [[VW Passat (3C) Parking Brake#Coding|Parking Brake Control Module Coding]].
*** Check [[VW Passat (3C) Parking Brake#Coding|Parking Brake Control Module Coding]].
** Check Brake Light Switch (F) Signal via #53 MVB 003.1
** Check Brake Light Switch (F) Signal via Parking Brake Control Module Measuring Value Block (MVB) 003.1
 
** Perform Selective Output Test (in Parking Brake Control Module)


[[Category:Fault Codes]]
[[Category:Fault Codes]]

Revision as of 13:09, 19 August 2007

02844 - Lamp for Automatic Parking Function

02844 - Lamp for Automatic Parking Function: Open or Short to Ground

Possible Symptoms

  • Malfunction Indicator Light (MIL) active

Possible Causes

  • Control Module incorrectly coded, Auto-Hold not installed
  • Wiring/Connectors from/to Brake Light Switch (F) faulty
  • Wiring/Connectors from/to Lamp for Auto-Hold (K237) faulty

Possible Solutions

  • Perform Output Test
  • Check Control Module Coding
  • Check Wiring/Connectors from/to Brake Light Switch (F)
  • Check Wiring/Connectors from/to Lamp for Auto-Hold (K237)

Special Notes

  • When found in VW Passat (3C): Parking Brake
    • Check if Auto-Hold is installed, car data plate (sticker on 1st page of the service manual or identical sticker in the trunk) should have a UH2 tag.
    • Check Brake Light Switch (F) Signal via Parking Brake Control Module Measuring Value Block (MVB) 003.1
    • Perform Selective Output Test (in Parking Brake Control Module)