Difference between revisions of "17978/P1570/005488"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
RtWiKiSyS0p (talk | contribs) m |
||
| Line 16: | Line 16: | ||
* Check Immobilizer Measuring Values (usually in Instrument Cluster OR Immobilizer Control Module) | * Check Immobilizer Measuring Values (usually in Instrument Cluster OR Immobilizer Control Module) | ||
| − | * Match Key(s)/Instrument Cluster/Engine Control Unit (ECU) | + | * [[Diagnostic Procedures#Immobilizer Information|Match Key(s)/Instrument Cluster/Engine Control Unit (ECU)]] |
* Check Engine Control Unit (ECU) Power Supply (Relay) | * Check Engine Control Unit (ECU) Power Supply (Relay) | ||
Revision as of 04:43, 20 January 2009
17978/P1570/005488 - Engine Start Blocked by Immobilizer
Possible Symptoms
- Engine starting but stalling immediately
Possible Causes
- Key(s) not matched
- Instrument Cluster not matched
- Engine Control Unit (ECU) not matched
- Engine Control Unit (ECU) Power Supply faulty
Possible Solutions
- Check Immobilizer Measuring Values (usually in Instrument Cluster OR Immobilizer Control Module)
- Match Key(s)/Instrument Cluster/Engine Control Unit (ECU)
- Check Engine Control Unit (ECU) Power Supply (Relay)
Special Notes
- If no other immobilizer related fault codes are stored and the immobilizer related meas. blocks are fine except Engine Start not allowed, in rare occasions it helps to try cold-booting the car. Remove both battery cables from the battery. Short the battery cables together (away from the battery) for about 15 seconds. Reconnect the battery. (Example)