01487: Difference between revisions

Revision as of 21:23, 13 July 2011

When found in Brake Electronics Control Module (J104)
- Brake Electronics Function Test Timed Out

When found in Brake Electronics Control Module (J104)
- Perform Brake Electronics Function Test

When found in Brake Electronics Control Module (J104)
- The Function Test on most ABS/ESP Systems should not exceed more than 50 Seconds

When found in Control Module for Level Control (J197)
- Internal Error in Control Module for Level Control (J197)
- Control Module for Level Control (J197) faulty

When found in Audi A8 (4E): Level Control (J197), this Fault Code can have several different Causes but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197).

@@ Line 14: / Line 14: @@
 ==== Possible Solutions ====
-* Perform Brake Electronics Function Test (again)
+* When found in Brake Electronics Control Module (J104)
+**  Perform [[ESP System Function Test|Brake Electronics Function Test]]
 ==== Special Notes ====
-* The Brake Electronics Function Test on most ABS/ESP Systems should not exceed more than 50 Seconds
+* When found in Brake Electronics Control Module (J104)
+** The Function Test on most ABS/ESP Systems should not exceed more than 50 Seconds