Difference between revisions of "17090/P0706/001798"
From Ross-Tech Wiki
| Line 24: | Line 24: | ||
* In 01J-CVT Transmissions | * In 01J-CVT Transmissions | ||
** Check Transmission Measuring Value Block Group - 002 | ** Check Transmission Measuring Value Block Group - 002 | ||
| − | ** Check Selector Shaft for magnet damage | + | ** Check Selector Shaft for magnet(s) damage |
** Replace faulty J217-Transmission Controller (F125 is part of the J217) | ** Replace faulty J217-Transmission Controller (F125 is part of the J217) | ||
Revision as of 11:23, 5 May 2014
17090/P0706/001798 - Transmission Range Sensor (F125): Implausible Signal
Possible Symptoms
- No Reverse Lights
- Engine will not start (In 01J-CVT if Hall sensor 'D' fails)
- Incorrect gear selection
- PRNDL display may be flashing
Possible Causes
- Gear selector cable incorrectly adjusted
- F125-Transmission Range Sensor faulty
- Wiring or connection concerns
- In 01J-CVT Transmissions - Hall sensor or magnets concerns (there are four)
Possible Solutions
- Adjust gear selector cable
- Check Transmission Measuring Value Blocks
- Replace faulty F125-Transmission Range Sensor
- Repair/replace wiring or connection concerns
- In 01J-CVT Transmissions
- Check Transmission Measuring Value Block Group - 002
- Check Selector Shaft for magnet(s) damage
- Replace faulty J217-Transmission Controller (F125 is part of the J217)