Difference between revisions of "19000/P2568/009576"

From Ross-Tech Wiki
(Created page with "__FORCETOC__ == P2568 - Sensor for Ozone Reducing Radiator Identification: Implausible Signal == ==== Possible Causes ==== * Incorrect/wrong ID from the G611-Radiator Ident...")
 
Line 21: Line 21:
  
 
* The cooling surface of the radiator on some Volkswagen/Audi Group vehicles is coated with a catalyst that helps reduce Ozone, The G611 sensor monitors this function and is part of the federal emissions control of these vehicles which allows the manufacture to receive EPA 'credits'.  
 
* The cooling surface of the radiator on some Volkswagen/Audi Group vehicles is coated with a catalyst that helps reduce Ozone, The G611 sensor monitors this function and is part of the federal emissions control of these vehicles which allows the manufacture to receive EPA 'credits'.  
** This this technology is called PremAir®, see the BASF web site for more information.
+
** This technology is called PremAir®, see the BASF web site for more information.
 
** https://catalysts.basf.com/products-and-industries/mobile-emissions-catalysts/specialized-catalysts/premair  
 
** https://catalysts.basf.com/products-and-industries/mobile-emissions-catalysts/specialized-catalysts/premair  
  
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Revision as of 10:21, 25 June 2018

P2568 - Sensor for Ozone Reducing Radiator Identification: Implausible Signal

Possible Causes

  • Incorrect/wrong ID from the G611-Radiator Identification Sensor
  • Possible tapering or attempting to bypass the PremAir® system

Possible Solutions

  • Verify installation of G611-Radiator Identification Sensor on radiator.
    • Sensor can not be removed, doing so will cause intentional sensor damage.

Special Notes

  • The G611 communicates to the ECM via LIN-Bus, the sensor's unique ID (encrypted) and temperature.
    • There are no Measuring Value Block for this information.
  • Currently, the G611-Radiator Identification Sensor is not available separately, it comes with a new radiator when ordered from the vehicle's manufacture. The sensor will need to be attached to the radiator with AMV-195-KD1-01 adhesive, See Volkswagen Tech Tip 19-12-01 for more information.