Difference between revisions of "6-Speed Automatic Transmission (01J/Multitronic)"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
(→Coding) |
||
| Line 1: | Line 1: | ||
__FORCETOC__ | __FORCETOC__ | ||
== Coding == | == Coding == | ||
| + | To Code this transmission, make sure Ignition is ON, but Engine is NOT running. | ||
| + | |||
== Adaptation == | == Adaptation == | ||
== Special Procedures == | == Special Procedures == | ||
Revision as of 14:26, 4 December 2007
Coding
To Code this transmission, make sure Ignition is ON, but Engine is NOT running.
Adaptation
Special Procedures
Defined Test Drive
Prerequisites:
- Ignition ON and Engine ON.
- No Fault Codes stored.
- Transmission Oil Temperature must be between 60 °C and 90 °C.
- If the procedure does not succeed in the first try, make sure the temperature is above 80 °C.
- All driving and braking has to be done in partial load, avoid full throttle/braking!
- Normally the adaptation needs to be carried out when:
- Transmission Control Module has been recoded
- Input Shaft has been replaced
- Hydraulic Unit has been replaced
- Transmission Control Module has been replaced
- Transmission has been replaced
[Select]
[02 - Transmission]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Measuring Blocks - 08]
Block 010 (in 1st Row)
Block 011 (in 2nd Row)
[Go!]
Check fields 2, specification is ADP OK.
- Move the selector lever in position D and drive with partial load 20 m / 70 ft forward, then brake to standstill.
- Hold the brake for 10 seconds.
- Move the selector lever in position R and drive with partial load 20 m / 70 ft reverse, then brake to standstill.
- Hold the brake for 10 seconds.
The procedure needs to be repeated at least 5 times and can be repeated up to 10 times until the measuring values show ADP OK.
[Done, Go Back]
[Close Controller, Go Back - 06]