Difference between revisions of "01521"
From Ross-Tech Wiki
m |
m |
||
| Line 38: | Line 38: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * On Systems without Position Recognition (e.g. 1K-chassis Golf/Jetta or or 3C-chassis Passat), raise or lower the pressure in one | + | * On Systems without Position Recognition (e.g. 1K-chassis Golf/Jetta or or 3C-chassis Passat), raise or lower the pressure in one tire at a time and double check the Measuring Value Blocks (MVB) 001-012 (and 016) for changes. If you find one which does not change after raising or lowering the Pressure, you have most likely found the faulty Sensor. |
** ''Note: It may take up to 2 minutes before a pressure change is detected by the control module and displayed in the Measuring Value Block (MVB). To locate the individual Wheels it helps to make a note the Sensor Identification Number.'' | ** ''Note: It may take up to 2 minutes before a pressure change is detected by the control module and displayed in the Measuring Value Block (MVB). To locate the individual Wheels it helps to make a note the Sensor Identification Number.'' | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 19:12, 7 April 2008
01521 - Sensor for Tire Pressure
01521 - Sensor for Tire Pressure: Lower Limit Exceeded
Possible Symptoms
- Malfunction Indicator Light (MIL) active
Possible Causes
- Tire Pressure too Low
- Tire Pressure Sensor(s) not installed
- Winter Tires without Sensors
Possible Solutions
- Check Tire Pressure
- Check/Install Tire Pressure Sensors
01521 - Sensor for Tire Pressure: No Signal/Communication
Possible Symptoms
- Malfunction Indicator Light (MIL) active
Possible Causes
- Tire Pressure Sensor(s) faulty
- Tire Pressure Sensor(s) not installed
Possible Solutions
- Check/Install Tire Pressure Sensors
- Check individual Sensors via Measuring Value Blocks (MVB)
Special Notes
- On Systems without Position Recognition (e.g. 1K-chassis Golf/Jetta or or 3C-chassis Passat), raise or lower the pressure in one tire at a time and double check the Measuring Value Blocks (MVB) 001-012 (and 016) for changes. If you find one which does not change after raising or lowering the Pressure, you have most likely found the faulty Sensor.
- Note: It may take up to 2 minutes before a pressure change is detected by the control module and displayed in the Measuring Value Block (MVB). To locate the individual Wheels it helps to make a note the Sensor Identification Number.