Difference between revisions of "Audi A8 (4E) Battery Replacement"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) (New page: __FORCETOC__ '''This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery ...) |
RtWiKiSyS0p (talk | contribs) m |
||
| Line 2: | Line 2: | ||
'''This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery management control module is a slave/subsystem of the gateway.''' | '''This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery management control module is a slave/subsystem of the gateway.''' | ||
| − | ''The following procedure does assume you are using a battery supplied by VW/Audi, all necessary details for the following steps can found on the battery itself.'' | + | ''The following procedure does assume you are using a battery supplied by VW/Audi, all necessary details for the following steps can found on the battery itself. Make sure to refer to the factory repair manual in order to fulfill all additional prerequisites.'' |
'''[Select]'''<br> | '''[Select]'''<br> | ||
Revision as of 09:11, 25 June 2008
This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery management control module is a slave/subsystem of the gateway.
The following procedure does assume you are using a battery supplied by VW/Audi, all necessary details for the following steps can found on the battery itself. Make sure to refer to the factory repair manual in order to fulfill all additional prerequisites.
[Select]
[61 - Battery Regulation]
[Coding - 07]
[Battery Coding Assistant]
- Enter the new Battery Part Number (10 or 11 digits).
- Enter the new Battery Serial Number (10 digits).
- Select the new Battery Vendor.
[OK]
[Do it!]
[Close Controller, Go Back - 06]
Your new Battery should now be coded and the Battery Control Module should be aware of the new Battery.