Difference between revisions of "Bentley Continental (3W) Tire Pressure Monitoring"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) (New page: == Coding == == Special Procedures == === Initialization === '''[Select]'''<br> '''[65 - Tire Pressure Monitoring]'''<br> '''[Security Access - 16]'''<br> Enter 10896, to enable the Ini...) |
RtWiKiSyS0p (talk | contribs) |
||
| Line 7: | Line 7: | ||
'''[Select]'''<br> | '''[Select]'''<br> | ||
'''[65 - Tire Pressure Monitoring]'''<br> | '''[65 - Tire Pressure Monitoring]'''<br> | ||
| + | '''[Measuring Blocks - 08]'''<br> | ||
| + | Group 019<br> | ||
| + | '''[Go!]'''<br> | ||
| + | Check Field 1, it should show the Initialization Status. If the Initialization has already been performed skip the following Steps and directly start with driving the Vehicle.<br> | ||
'''[Security Access - 16]'''<br> | '''[Security Access - 16]'''<br> | ||
Enter 10896, to enable the Initilization.<br> | Enter 10896, to enable the Initilization.<br> | ||
| Line 28: | Line 32: | ||
'''[Close Controller, Go Back - 06]'''<br><br> | '''[Close Controller, Go Back - 06]'''<br><br> | ||
| − | * Now drive the vehicle until all Wheel Pressure Sensors report plausible Values (either in the Infotainment System or the Instrument Cluster). If the Sensors do not report proper values after a 30 Minute drive there may be a Problem with the Antennas, in such a case you should perform an Antenna Diagnosis. | + | * Now drive the vehicle until all Wheel Pressure Sensors report plausible Values (either in the Infotainment System or the Instrument Cluster). |
| + | * If the Sensors do not report proper values after a 30 Minute drive there may be a Problem with the Antennas, in such a case you should perform an Antenna Diagnosis. | ||
Revision as of 11:45, 29 April 2009
Coding
Special Procedures
Initialization
[Select]
[65 - Tire Pressure Monitoring]
[Measuring Blocks - 08]
Group 019
[Go!]
Check Field 1, it should show the Initialization Status. If the Initialization has already been performed skip the following Steps and directly start with driving the Vehicle.
[Security Access - 16]
Enter 10896, to enable the Initilization.
[Do it!]
[Adaptation - 10]
Adaptation Channel 001
[Read]
Enter 0 as new Value.
[Save]
- Check the Tire Pressure for all 4/5 wheels and if necessary correct it.
Adaptation Channel 004
[Read]
Enter 1 as new Value.
[Save]
[Done, Go Back]
[Measuring Blocks - 08]
Group 019
[Go!]
Check Field 1, it should show the Initialization Status.
[Done, Go Back]
[Close Controller, Go Back - 06]
- Now drive the vehicle until all Wheel Pressure Sensors report plausible Values (either in the Infotainment System or the Instrument Cluster).
- If the Sensors do not report proper values after a 30 Minute drive there may be a Problem with the Antennas, in such a case you should perform an Antenna Diagnosis.