Difference between revisions of "02628"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) |
|||
| Line 13: | Line 13: | ||
** Connectors not properly attached AND/OR Pins widened | ** Connectors not properly attached AND/OR Pins widened | ||
** Connectors wet/corroded | ** Connectors wet/corroded | ||
| − | * Sensor for Swivel Module Position Right faulty | + | * G475 - Sensor for Swivel Module Position Right faulty |
==== Possible Solutions ==== | ==== Possible Solutions ==== | ||
Revision as of 09:56, 27 September 2013
02628 - Sensor for Swivel Module Position; Right
02628 - Sensor for Swivel Module Position; Right : Defective
Possible Symptoms
- Malfunction Indicator Light (MIL) active
Possible Causes
- Wiring/Connectors from/to Sensor for Swivel Module Position Right faulty
- Connectors not properly attached AND/OR Pins widened
- Connectors wet/corroded
- G475 - Sensor for Swivel Module Position Right faulty
Possible Solutions
- Check/Repair Wiring/Connectors from/to Sensor for Swivel Module Position Right
- Check/Replace Sensor for Swivel Module Position Right
- Sensor may be part of the Headlight and the complete Headlight may need to be replaced
Special Notes
- When found in Volkswagen Passat (3C): Headlight Leveling, check TPI 2012732.
- If the Fault Code is static (not intermittent) and the Right Subsystem/Slave Swiveling Module has Software Level X017 or lower just replace the Swiveling Module - do NOT replace the Headlight/Housing at this point.
- If the Fault Code is intermittent and the Right Subsystem/Slave Swiveling Module has Software Level X017 or lower replace the Swiveling Module and the Headlight/Housing.
- If the Right Subsystem/Slave Swiveling Module has Software Level X018 replace only the Headlight/Housing.