Difference between revisions of "User:Jef"
From Ross-Tech Wiki
| Line 61: | Line 61: | ||
== Special Notes == | == Special Notes == | ||
| − | |||
---- | ---- | ||
| − | |||
*These instructions should work with most non-USD Level Control systems found in: | *These instructions should work with most non-USD Level Control systems found in: | ||
| Line 78: | Line 76: | ||
== Video Link == | == Video Link == | ||
| + | ---- | ||
=== Suspension Leveling Calibration === | === Suspension Leveling Calibration === | ||
Revision as of 16:26, 28 March 2018
Prerequisites:
- Doors, hood and rear lid closed
- Engine at idle, parking brake set
- Parked on level surface
- Metric tape measure
Measuring the ride height is done from the center of the wheel, vertically, to the edge of the fender to the closest millimeter.
[Select]
[34 - Level Control]
[Security Access - 16]
Enter 31564
[Do It!]
- If the Security Access code does not work, try 31564 in [Login - 11] or [Coding II - 11]
[Adaption - 10]
Channel 01 (front left)
[Read]
- A message of "Wait" will be displayed while the right height is adjusted.
- When message changes to "Value", take the measurement at front left.
- Input the New value in millimeters.
[Test]
[Save]
[Yes]
Channel 02 (front right)
[Read]
- Take measurement at right front.
- Input the New value in millimeters.
[Test]
[Save]
[Yes]
Channel 03 (rear left)
[Read]
- Take measurement at left rear.
- Input the New value in millimeters.
[Test]
[Save]
[Yes]
Channel 04 (rear right)
[Read]
- Take measurement at right rear.
- Input the New value in millimeters.
[Test]
[Save]
[Yes]
Channel 05
[Read]
New value 1
[Test]
[Save]
[Yes]
[Done, Go Back]
Special Notes
- These instructions should work with most non-USD Level Control systems found in:
- A6
- A8
- Q7
- Phaeton
- Touareg
- Bentley Continental.
- Additional links on this topic
Video Link
Suspension Leveling Calibration
