Difference between revisions of "01279"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
|||
| Line 33: | Line 33: | ||
* Perform Longitudinal Acceleration Sensor (G251) Basic Setting | * Perform Longitudinal Acceleration Sensor (G251) Basic Setting | ||
** See Vehicle specific [[Diagnostic Procedures]] for Details | ** See Vehicle specific [[Diagnostic Procedures]] for Details | ||
| + | |||
| + | |||
| + | ==== Special Notes ==== | ||
| + | |||
| + | *The Longitudinal Acceleration Sensor - G251, is only installed for vehicles that have at least one of the following options: | ||
| + | **1X1: Four-wheel drive | ||
| + | **UG1: Hill start assist | ||
| + | **UG4: Hill hold | ||
| + | **7X5: Park assist | ||
| + | **7X6: Park Assist with rear camera | ||
| + | **8T3: Distance control (ADC) | ||
| + | **7L6: Start-Stop system | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 11:42, 4 October 2024
01279 - Longitudinal Acceleration Sensor (G251)
01279 - Longitudinal Acceleration Sensor (G251): Implausible Signal
Possible Symptoms
- Malfunction Indicator Lamp (MIL) active
Possible Causes
- Longitudinal Acceleration Sensor (G251) Calibration not performed
- Wiring/Connectors from/to Longitudinal Acceleration Sensor (G251) faulty
Possible Solutions
- Check Longitudinal Acceleration Sensor (G251)
- Use Measuring Value Blocks (MVB) to check Sensor Signal for plausibility
- Check Installation Position of Longitudinal Acceleration Sensor (G251)
- Perform Longitudinal Acceleration Sensor (G251) Calibration
- See Vehicle specific Diagnostic Procedures
- Check Wiring/Connectors from/to Longitudinal Acceleration Sensor (G251)
01279 - Longitudinal Acceleration Sensor (G251): No or Incorrect Basic Setting / Adaptation
Possible Causes
- Longitudinal Acceleration Sensor (G251) Basic Setting lost/not performed
Possible Solutions
- Perform Longitudinal Acceleration Sensor (G251) Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
Special Notes
- The Longitudinal Acceleration Sensor - G251, is only installed for vehicles that have at least one of the following options:
- 1X1: Four-wheel drive
- UG1: Hill start assist
- UG4: Hill hold
- 7X5: Park assist
- 7X6: Park Assist with rear camera
- 8T3: Distance control (ADC)
- 7L6: Start-Stop system