01826
From Ross-Tech Wiki
Revision as of 17:03, 27 April 2007 by RtWiKiSyS0p (talk | contribs)
01826 - Sensor for Steering Angle (G85); Supply Voltage Terminal 30
Possible Symptoms
- Malfunction Indicator Light (MIL) active
Possible Causes
- Temporary Supply Voltage Interruption
- Steering Angle Sensor (G85) faulty
- Steering Column Control Module (J527) faulty
Possible Solutions
- Perform Steering Angle Sensor (G85) Adaptation
- See Vehicle specific Diagnostic Procedures for Details
- Check/Replace Steering Angle Sensor (G85)
- Check/Replace Steering Column Control Module (J527)
Special Notes
- When found in Audi A4/S4/RS4/Cabriolet (8E/8H): Brake Electronics, these are the most likely causes if the Basic Setting fails or the Fault comes back shortly after clearing.
- MY 2001: Steering Column Control Module (J527) was the most common fault
- MY 2002: Steering Angle Sensor (G85) was the most common fault
- MY 2003/2004: Experience has shown the Steering Angle Sensor (G85) were the only cause, Steering Column Control Module (J527) were not defective yet.
- MY 2006: Steering Column Control Module (J527) was the most common fault