Immobilizer II ECU Swapping

From Ross-Tech Wiki
Revision as of 16:35, 10 September 2010 by Jef (talk | contribs) (Created page with '''Ross-Tech is not responsible for any damage or problems that may result from following these instructions. They are to be used at your own risk. As always, you should refer to …')
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Ross-Tech is not responsible for any damage or problems that may result from following these instructions. They are to be used at your own risk. As always, you should refer to a Factory Repair Manual for your vehicle!

ECM Matching

Prerequisites:

  • Battery voltage at least 12.5 V.
  • Immobilizer II ECM

[Select]
[17 - Instruments]
[Adaption - 10]
Leave channel at "00"
[Read]
[Save]

[Done, Go Back]
[Close Controller, Go Back - 06]
[Exit]

Turn ignition OFF for 15 seconds. Start vehicle.

Retrieved from "http://wiki.ross-tech.com/wiki/index.php?title=Immobilizer_II_ECU_Swapping&oldid=5074"