Bentley Continental (3W) Brake Electronics (Bosch 8.1)
Security Access
Note #1: After the Security Access - 16 (Login) has been carried out you need to Recode the control module then perform the Steering Angle Sensor Calibration. Do NOT exit the Control Module in between the individual steps.
- 03121 = Bentley Continental Flying Spur (3W2/BY611)
- 02121 = Bentley Continental GT/Cabrio (3W3/BY614 - 3W4/BY615)
- 02321 = Bentley Continental GT Diamond Series (3W3/BY614)
Coding
Note #1: Coding is accepted after a specific login has been carried out.
Note #2: After successful coding the steering angle sensor basic setting needs to be carried out.
Note #3: In some cases, you will need to enter a non-zero WorkShop Code, such as 12345.
- 0006878 = Bentley Continental Flying Spur (3W2/BY611)
- 0007878 = Bentley Continental GT/Cabrio (3W3/BY614 - 3W4/BY615)
- 0007678 = Bentley Continental GT Diamond Series (3W3/BY614)
Basic Setting
Steering Angle Sensor (G85) Calibration
Before starting the procedure turn the steering wheel at least 30 ° left and back straight ahead.
[Meas. Blocks - 08]
Group 005 Field 1 (Steering Angle Sensor -G85-)
Specification: 0.0 °
Tolerance (when straight): ±5.0 °
[Done, Go Back]
[Security Access - 16]
Enter 40168
[Do It!]
[Basic Settings - 04]
Group 001
[Go!]
[Done, Go Back]
[Fault Codes - 02]
All fault codes should have disappeared.
[Done, Go Back]
[Close Controller, Go Back - 06]