Cruise Control Retrofitting (6R)

Requirements

Central Electronics Control Module

There are 5 Types of Body Control Modules (BCM/J519), only 3 of them support Cruise Control. The installed Type can easily be determined by the Control Module Part Number. Higher equipped Types always include the Options from the lower equipped ones.

• Basis+
  • Part Numbers: ***-937-084-***
• Medium+
  • Part Numbers: ***-937-085-***
  • Supported Features: Central Locking, Anti-Theft-System, Outside Mirror Heating, Seat Heating
• Medium++
  • Part Numbers: ***-937-086-***
  • Supported Features: Remote Control
• High+
  • Part Numbers: ***-937-087-***
  • Supported Features: Cruise Control System (CCS), Anti-Theft-System LIN-Databus (for Alarm Horn)
• TBD
  • Part Numbers: ***-937-088-***
  • Supported Features:
• TBD
  • Part Numbers: ***-937-089-***

Installation & Wiring

• Install proper Cruise Control Switch/Lever
• Add the Wiring from Cruise Control Switch/Lever to Central Electronics Control Module (J519)
• Add the Wiring from Cruise Control Switch/Lever to Fuse Box C

Additional Information can be found in the Repair Manuals, the Wiring Diagrams, the Parts Catalog and/or the Instructions included in the Retrofitting Kit.

Configuration

The following Activations are necessary to ensure that the newly fitted parts are properly recognized and are ready to use.

• Update the Central Electronics Control Module (J519 / #09) Coding.
  • Due to different Control Modules and Equipment in the Car the actual Coding Table is not shown here but will automatically be used by the Long Coding Assistant once you access the Function using VCDS.
• Update the Engine Control Module (J623 / #01) Coding.
  • Make sure that the Engine is NOT running, otherwise the new Coding will be rejected. Models equipped with Start/Stop System do have a Shutoff Switch/Button which will deactivate the Start/Stop Function.
  • Due to different Control Modules and Equipment in the Car the actual Coding Table is not shown here but will automatically be used by the Long Coding Assistant once you access the Function using VCDS.

If you are having trouble finding/calculating the proper Coding using the Long Coding Assist please Contact us directly. Make sure to include a complete Diagnostic Protocol (Auto-Scan) from the Car and state which steps/work you have performed yet.