02830

From Ross-Tech Wiki
Revision as of 18:31, 22 September 2007 by RtWiKiSyS0p (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

02830 - Control Circuit for CAN Isolator for Driver Assistance Systems

02830 - Control Circuit for CAN Isolator for Driver Assistance Systems: Electrical Fault in Circuit

Possible Causes

  • Supply Voltage insufficient
  • Control Module Coding incorrect

Possible Solutions

  • Check Control Module Power Supply
  • Check CAN-Gateway Coding (see Vehicle specific Diagnostic Procedures).
  • Check CAN-Databus Powertrain Cut-Off Relay (J788)
    • Check Measuring Value Blocks (MVB)
    • Perform Output Test and check for an audible noise while the Relay is being actuated.

Special Notes

  • When found in VW Passat (3C): CAN-Gateway, check Measuring Value Block (MVB) 002.3 while cycling the Ignition. It should change between active and passive.
Retrieved from "http://wiki.ross-tech.com/wiki/index.php?title=02830&oldid=4005"