17087/P0703/001795
From Ross-Tech Wiki
Revision as of 08:15, 2 July 2010 by RtWiKiSyS0p (talk | contribs) (Created page with '== 17087/P0703/001795 - Brake Switch (F): Electrical Malfunction == ==== Possible Symptoms ==== * Malfunction Indicator Light (MIL) ON ==== Possible Causes ==== * Wiring and/…')
17087/P0703/001795 - Brake Switch (F): Electrical Malfunction
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
Possible Causes
- Wiring and/or Connector(s) from/to Brake Switch (F) faulty
- Brake Switch (F) faulty
Possible Solutions
- Check Wiring and/or Connector(s) from/to Brake Switch (F)
- Check/Replace Brake Switch (F)
Special Notes
- When found in Vehicles with Drive-by-Cable (DBC) the Brake Switch (F) is connected to the Transmission Control Module. On older Models this Code is stored automatically after Terminal 15/Ignition is switched ON. If the Brake Switch (F) is OK you can avoid this Fault Code by pressing the Brake Pedal after switching on the Ignition and prior to checking Fault Codes. The Code should automatically be cleared then.
- When found in Vehicles with Drive-by-Wire (DBW) the Brake Switch (F) is connected to the Engine Control Module In this case you should check the Engine Control Module for Fault Codes as well and the Data Bus Wiring between Engine and Transmission Control Module.