Difference between revisions of "00003"

From Ross-Tech Wiki
 
Line 53: Line 53:
  
 
=== Video Link ===
 
=== Video Link ===
[[File:ABS_025_-_026_thumb.jpg|200px|link=https://www.youtube.com/watch?v=b6lm9OmC2so]]
+
[[File:ABS_025_-_026_thumb.jpg|alt="Video thumbnail for fault 00003 guide"|200px|link=https://www.youtube.com/watch?v=b6lm9OmC2so]]
  
 
https://www.youtube.com/watch?v=b6lm9OmC2so
 
https://www.youtube.com/watch?v=b6lm9OmC2so
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Latest revision as of 12:58, 25 September 2021

00003 - Control Module

00003 - Control Module: Defective

Possible Causes

  • Control Module faulty
  • Control Module Software Issue

Possible Solutions

  • Check Control Module
    • Check for Control Module Software Update
  • Replace Control Module

Special Notes

  • When found in Radio OR Radio Navigation System, check Measuring Value Block (MVB) 025.1 for Details.
    • Measuring Value Block 025.1 (MVB) may not be supported by all Radios OR Radio Navigation Systems.
  • When found in Audi A8/S8 (4E): Audi A8 (4E) Brake Electronics, this Fault Code may have been stored after performing an Output Test in the Brake Electronics Control Module w/o following the proper Instructions. To clear this Fault Code, please perform/repeat the following Steps 3 (THREE) times:
    • Switch the Ignition OFF for 5 Seconds, then Switch it ON again.
    • Clear Fault Codes in Brake Electronics Control Module, then exit out of the Control Module.

00003 - Control Module: No or Incorrect Basic Setting / Adaptation

Possible Causes

  • Basic Setting(s) not performed

Possible Solutions

  • Perform Basic Setting(s)

Special Notes

Note most RoW (Rest of World) market Audi models support 3 total service related reset procedures. The Basic Oil Change, Time based and Distance based resets may need to be completed before 00003 - Control Module: No or Incorrect Basic Setting / Adaptation will clear.

00003 - Control Module: Mechanical Failure

  • When found in [28] - Heating/Air Conditioning (Rear) in the Audi Q7 (4L/FE) chassis this may be caused by activated child locks (i.e. main window switch lock-out active). The rear display may show (- - -). The following TPIs apply:
    • RoW market 2014727
    • NAR market 2014876

Video Link

"Video thumbnail for fault 00003 guide"

https://www.youtube.com/watch?v=b6lm9OmC2so