Difference between revisions of "00149"
From Ross-Tech Wiki
(Created page with "__FORCETOC__ == 000149 - End of Line Programming not Completed == ==== Possible Causes ==== * Control module was replaced ==== Possible Solutions ==== * An online connecti...") |
|||
| Line 9: | Line 9: | ||
* An online connection with the manufacture is required for Parameterization via the SVM (Software Version Management). | * An online connection with the manufacture is required for Parameterization via the SVM (Software Version Management). | ||
| + | * When found in Golf 5 and 6 based [[VW Scirocco (13) Suspension Electronics | 14-Susp. Elect. (J250)]] control modules, see this [https://forums.ross-tech.com/showthread.php?4011-error-00149-End-of-Line-Programming-not-Completed-dcc-el-suspension forum thread]. | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
Revision as of 10:08, 20 September 2019
000149 - End of Line Programming not Completed
Possible Causes
- Control module was replaced
Possible Solutions
- An online connection with the manufacture is required for Parameterization via the SVM (Software Version Management).
- When found in Golf 5 and 6 based 14-Susp. Elect. (J250) control modules, see this forum thread.
Special Notes
- Parameterization refers to data written into the control unit by the SVM function (Software Version Management) to customize the software functionality for the specific vehicle or country of operation.
- Often referred to as the “calibration data”, it is necessary Parameterization is performed anytime there is missing or invalid data-set fault codes and/or it is suggested by SVM test plan to ensure the proper functionality of the control unit.
- Not all control units are parameterized by SVM.
- Parameterization MUST BE PERFORMED to ensure the control unit will function properly in the vehicle!