Difference between revisions of "00741"
From Ross-Tech Wiki
(Created page with '== 00741 - Brake Pedal Monitoring == ==== Possible Symptoms ==== * No accelerator pedal response * Poor engine performance * Glow Plug light flashing ==== Possible Causes ==…') |
|||
| Line 18: | Line 18: | ||
* Inspect brake light bulb sockets for damage. | * Inspect brake light bulb sockets for damage. | ||
* Test Brake Light Switch F47 | * Test Brake Light Switch F47 | ||
| − | + | ||
| − | + | ==== Special Notes ==== | |
| − | + | ||
| − | + | * On ALH engine, go into Engine then Measuring Blocks group 006, Field #2 | |
| + | * Foot off brake #2 should read 000 | ||
| + | * Slowly press on brake, should then read 011 with both "1" activating at the same time | ||
| + | * If both "1" do not activate at same time, Brake Ligth Switch may be defective. | ||
__FORCETOC__ | __FORCETOC__ | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 11:59, 4 February 2011
00741 - Brake Pedal Monitoring
Possible Symptoms
- No accelerator pedal response
- Poor engine performance
- Glow Plug light flashing
Possible Causes
- Issue with Brake Light Switch F47
- Issue with Brake Lights
Possible Solutions
- Verify correct brake light bulbs are installed.
- Inspect brake light bulb sockets for damage.
- Test Brake Light Switch F47
Special Notes
- On ALH engine, go into Engine then Measuring Blocks group 006, Field #2
- Foot off brake #2 should read 000
- Slowly press on brake, should then read 011 with both "1" activating at the same time
- If both "1" do not activate at same time, Brake Ligth Switch may be defective.